开云体育

Very possibly. Is there a way for the user to do that? I checked LDG's website and found nothing on support. Sent them an email earlier today, no reply yet.

Sounds like the software may need to be reflashed. -- Al Skierkiewicz WB9UVJ

I recently acquired a used Z-817 tuner for my FT-817. I set the CAT to 38400 as specified in the FT-817. No cables to computer - just the FT-817 and Z-817. When I hit the tune button on the Z-817, the

Thanks Ron All good.?? I had success this afternoon by using USER-L submode on my rig.?? The passbands seem to be the same so I'll see how it goes.?? One of my QSO partners was using an FT-991A

I have a transformer interface for my fT817 and connected it to the rear DATA jack.? Need to put the FT817 in data mode to select this jack. Then when using FLDigi you let the program generate the

Hello all, I would like to set up FLDIGI and my FT-817ND.?? My transformer-isolated interface with PTT activated by right-hand audio channel, works well.?? The mode "DIG" is set to the RTTY

Oh, yep, my misunderstanding. I hope OP will post with what they’ve found. I did get one of the WindCamp Anderson Power Pole adapters for my 818. I like the solid feel and design of it versus the 3D

Sorry, I automatically assumed everyone uses the z817

Hi Pat, You don't say which ldg tuner you use but I use a z817 with my ft817nd and I plug the pc cable into the port on the tuner. The tuner then passes info to the radio. I do have to set the baud

Okay, I'm not sure if I'm setting it up wrong but I use flrig my linux laptop to control my radio but every time I try to choose 817 in flrig, flrig freezes. I also have an 897D and an 857D and they

Having had a similar failure on my own, I would suggest checking the internal SMD fuse on the radio - I killed mine, and had to replace the surface mount component to get the device back :-) Kindest

This DC connector is the glass jaw of the 817. The connector failed in my 20yr old 817 so I ripped the old connector out and soldered wires in it's place going to a JST connector thru the now open

I noticed on mine the other day, that the plug on the Yaesu wall wart doesn't seem to be mating properly with the power jack on the radio. A different plug that I have which is connected to a LiFePo4

He already said it's not. Zack W9SZ [email protected]> wrote:

Look At the Male Plug And see if the tiny "Plastic" tip is Possibly Missing and Now STUCK In The? Female Socket. If so Its "Fun" Getting it OUT. -- Best Regards. Steve AB2ET/4

I had the power connector on mine go dead. When I opened up the case and looked at the pc board, I saw a couple chip capacitors on the board. One had apparently shorted and burned the DC input circuit

The DC connector is a definite weak point. There is a very thin PCB track which can fracture. Also, frequently taking the plug out and back in again can loosen the solder joints from the socket to the

Op is talking about not getting DC power through the rear power input not power from the RF connectors.

I'm going to go with the help desk first question: Did you check that menu setting 7 is set to the rear connector? 72 de Bryan, k0emt On Thursday, September 1, 2022 at 02:32:36 PM EDT, Steve Rosman

I guess that a visual inspection is not enough. You have to use test equipement because not all problems can be seen with your eyes. I also had a broken connection after resoldering all worked fine