开云体育

It's not something that's discussed often, there is also an option of getting a KF700/S with a slider and upgrading the slider later to a longer one that's compatible with the chassis length. But yes

I have a Hammer C3-41 with the 79 inch table. I have found that the back 20 inches of the sliding table gradually "kicks up" more than 0.020". Almost like the tail of a skateboard. The remainder of

Yes, I did visit the showroom and there is no doubt that 700s are a big step up in overall feel and finish over a B3. However, it is not a free choice. I think everyone here agrees that buying a short

Hey Stan, Did you mention where your located? If a showroom isnt near by, might be someone with a unit you can get up to and see. Either way I think your making the right decision going for a Euro

With straight knives do I really have to check the boards carefully for grain direction vs spiral that it doesn't matter so much?

Hi Stan, Are you located near a Felder showroom. If not, I will highly recommend checking here for someone near you so you can see both Hammer and Felder in person. It will also benefit to learn how

Sorry to hear you will not be able to enjoy this equipment. Good luck to you!

Has anyone made a file for this doohickey? 2001 vintage KF700. -- Jason J. Holtz Furniture 3307 Snelling Ave. South Minneapolis, MN 55406

Wade, The single machine kit will Include the T-nut with screws. you would need to send your aluminum + Kipp lever for modification. If you want to keep your aluminum block you are welcome to buy a

Stan, Good that all the contributions allowed you to define the approach that suits you. Whether you choose a Hammer or a Felder unit, you will enjoy the quality and the pleasure of working with good

Imram - after googling, I guess you are correct.?? I just have never seen a machine in that configuration. Brian - the one problem area I have seen on the Nova Voyager is the design of the

Hi Aaron, Isn’t it similar to Reeves drive in principle which is used on machines? I have not kept up on CVTs but Honda, Nissan and Toyota all use them. The interesting fact in early development was

I too will take a set for a single KF700 Just let me know when and where to send $$$ Thanks to you and David for all the effort you have put into this project. Sure would be nice if Felder would

The Powermatic 2800B uses what is called a Constantly Variable Transmission (CVT) -- (inside the 2800B, it's actually 2 separate CVTs).? I have not seen any other woodworking machinery that uses this

Hi Stan, At least you know where you want to go.?? You are kind of undecided between the 1250mm table and the 2000mm table (cutting length define the max table movement and are actually misleading

Add me to the list for a single set. ?Thanks for taking this on… Mike M.E. Blake General Contractors

Hello FOG, I have a brand new AD941, a RL 140 and a Nova Voyager drill press for sale. I am located in Austin, Texas. After a really long wait to get all of them I am moving and will not be able to

Hi Stan, Good to know on the PM2800B. Looking at the exploded parts diagram, it looks like those drill presses use an entirely different mechanism than the 2820EVS, so whatever the issue was on the

Hi Kevin, I assume you are asking me about my write-up of the many I shared. If so, I should be able to confirm, if you share the electrical schematic of your machine with me. You can share it here or

Imran, any idea if this will also work for a K3?