开云体育

There are commissioning checklists in the files section. Sounds like you’re in for a long night of supervision.

David, I hope it is that simple! I will not do anything with it until the tech gets here, though. I do not want Felder telling me I broke something! I appreciate the input about possible

Weird, I don't have that knob/shaft attached to mine. I'll have to look at my loose parts that came with my machine to see if it's laying around. -- *Larry Long Neck* Just a noob trying to learn the

Most likely then, the bearing cage needs to be centered. To do this, force the sliding table to the absolute extreme end of travel in both directions. That will center the bearing cage. David Best -

Natanel, I know I sent you my photos but that "Knob and shaft" are definitely attached to the motor mount to lock the tension. PK

Yes, I did. -- John Hinman Boise ID Kappa 450X and A941

Hi, I do a fair amount of template copying and have never had an issue with using a pattern that bridges the cast and sliding table. The angle induced is so small as to inconsequential . When tenoning

Did you remove the plastic transporting locking dowels that are wedged in between the bearing ways of the lower carriage and the sliding table? David Best - via mobile phone

I guess I should also point out that for template pattern work, I use a spiral cutter that is only 100mm in diameter with an integral rub bearing. https://flic.kr/p/PtnUYq David Best - via mobile

Today is the day! Tech is supposed to arrive late this afternoon for commissioning. I did mount the slider onto the saw, so I could verify clearances. This slider is very hard to move. It takes two

Frankly, I have never had a situation where the tiny induced angle was an issue during template routing. I mean we’re talking about less than 0.1° here. But if I was truly concerned about it, I

David and Imran, Thanks again for your valuable feedback. David, there is one more question relating to template routing - how do I fit this into the equation of having the slider 0.15mm higher than

Netanel, I wired my power feed outlet on my go Gomad so it has its own push button to start on my panel so I can test it without the shaper running and when its feeding with the shaper of running and

Nate, Repeating what David said a little differently. Loosen the lock for swinging the PF between horizontal and vertical and lift up on black knob up front (pink arrow) and lock it in the desired

Given that your base cabinets are already in place, do yourself a huge favor and pick up a pair of Third Hand cabinet jacks from Fastcap. They make installing the uppers in this situation a breeze.

Neither one of those t-nuts will meet the requirements. You need two set-screws to anchor the T-nut in the slider, and counterbores at each end so you can reverse the T-nut for leveling with grub

I am meeting tomorrow with the metal shop guy to discuss the final details. The new T-nut is still faulty and doesn’t register properly. Here is a comparison between the two. ill give more detials

Say more - I don’t understand. I was wondering today if you’d gotten a quote for the T-nut and how you were moving forward on this. David Best DBestWorkshop@...

With these two adjustment points you should be able to get the feeder tires perfectly aligned to be coplanar to the cast iron top: ? David Best DBestWorkshop@...

By the way, they also changed a bit the T nut that secured the short cross cut fence.