开云体育

David and Imran,

Thanks?again for your valuable feedback. David, there is one more question?relating to template routing - how do I fit this into the equation of having the slider 0.15mm higher than the cast iron? When you work using templates and remove the fence, do you simply cover the entire slider and cast iron with a material equivalent to the sled you described and cut out a hole the size of your cutterhead? It seems that I would need to be covering the beautiful cast iron table for a lot of my work - for template work and profiling wide boards on a sled. And the wide boards don't even need to be terribly wide since there is not much cast iron left before the slider interferes if I use a 180-200mm diameter cutterhead.