开云体育

Hi Mike, In the US, warranties generally start on the purchase date, while some start on the delivery or installation date. Basically, the warranty starts when you complete the purchase. If you

Hi Mike, Did this sit in Felder warehouse due to your request or it was just new old stock. In case latter is true, I think you have a strong case. I would also factor in how much of a break in

Minwax Wood Hardener is worth a try. Works well in my experience on mdf. [email protected]> wrote:

It's my understanding that the melamine will seal the faces, and if you use the plastic heat glue edge banding that will seal the edge. Then all you have to do is seal the slots that penetrate the

Maybe add one more melamine board with edge sealed (epoxy) underneath. James <mtgstuber@...> wrote:

This is a bit late, but perhaps it'll help someone else make a decision in future. I have an N4400 that in the few months I've owned it has been fine. Except that the fence head casting cracked and

Perhaps shellac? It is fast and relatively inexpensive, and easy to apply. It is compatible with most other finishes, so if does not do what you want you can try something else without removing the

Hi Folks, ??? I need some advice.? I've been working on making a vacuum press table.? I put together a torsion box and attached a melamine top to it.? I CNC cut channels in the melamine to

I ordered the short (50cm) support rail and will get Brian’s parallel fence.

That video with the indicator to the outside of the sliding table is misleading. The only reference surface on the sliding table that has been machined to be straight and parallel to the bearing ways

I second the Fein cordless multitool. Well designed tool! I use mine professionally all the time. Thx, Wade

If funds are tight, you already have the shorter extension table and you are able to pickup the end assembly of the Felder parallel fence from someone whose is collecting dust then what I did may be

Hi Aaron, All great points, but one thing, your indicating of the side of the slider is not on the area that the fence mounts to. Try the vertical face on the inside of the prism, that's what locates

David Best has a document that goes into detail on both the Felder and Lamb parallel fences.? That being said, there are two things that stopped me from going with the Felder parallel fence: 1.

I have Brian’s parallel fence as well as the felder version. The felder version is good if you mainly want to use the table extension part. However it is not very accurate to read as compared to

I use a specific procedure that I detailed in the DRO upgrade instructions, which i will attach here. It has been my experience that once set, they stay and don't need re-setting unless you change

Thanks everyone, If Felder's parallel guide sticks out 2m it is a deal breaker for me. From what I see, you always need to calibrate the parallel fence to a the blade (and usually use the same

I know Imran posted it to FB.. Free shipping on the Felder Website today - makes a few things way more affordable: * Fat 300 * Transport Cart * HS950 * Hammer J/P combos... PK

PK, thank you for the recommendation and comments. One other thing, I haven't experienced it, but folks claim the Felder unit has a lot of parallax error due to the height of the hairline pointer over

I have the felder and like it. But I would go with brians Get Outlook for iOS<https://aka.ms/o0ukef> ________________________________ Sent: Thursday, July 4, 2024 12:06:45 PM To: