开云体育

Brian, actually simple enough. The stop on the Incra fence slides along the face … All one has to do is run it to the near end. That will provide a very secure nook for the end of the board to be

Milescraft has a t-slot base that basically just bolts on to a Kreg 3" or 6" bench clamp.? The kit has a 30mm x 35mm t-bolt that fits into the X-Roll sliding table just fine.? I'm using these for

Thank you Jacques Please note all that I am not meaning to be divisive in my remarks. I was calling for unity by way of a supportive attitude. Incidentally, if you think my concept is flawed or crap,

Derek, that’s great that you have something that works for you. How do you do tapers and angles with that wide jig on the end? My reply was only in regards to shipping costs adding 50% to the price,

To say the least, I am somewhat surprised by the views expressed by some contributors in this thread. Members of FOG, in my mind, are knowledgeable people, willing to help others and interested in

If you are talking about the green festool thumb clamps they fit but barely. I feel like any clamping pressure would pop them up. I ordered some clamps from Mac, but in the meantime I just used a cnc

I’m not sure you need an adapter, I think the Festool clamp will fit in the sliders t-slot. Worst case you could 3D print a sleeve to take up any slop. Brian Lamb blamb11@...

There’s an adapter for using a Festool clamp on a slider? Does anybody have this adapter? Thx, Wade

Hi Derek: I thought I expressed that sentiment? Apologies if I wasn’t clear enough. I like your fixture a lot, particularly as we both do a lot of solid wood projects and use hand tools. I’m

I’m so very pleased for you Lourens. Your KF700 costs about four times my K3. Clearly, you have more discretional spending available than I, or your priorities are different. I don’t understand

Hi, Does anyone on here make the adapters that slide into the track of the K940 sliding table so I can mount a festool clamp into the groove? Thanks! JP

? David Best DBestWorkshop@... https://www.flickr.com/photos/davidpbest/collections/ https://www.youtube.com/@David_Best \

This is what tech support sent to me. The tech indicated that 36 was the macro adjustment and the hinge screws were micro adjustment. Even after loosing the 4 bolts below the hinge and making

Do we have a method of private conversation on this forum? ie can you email me so I can contact you directly? regards, Rod

US. I’ll be back in the shop on Monday. I took all the plates off so it should be pretty easy to get to. wrote:

I install the bottom cutter with a 5mm spacer underneath to accept the pin, same above the top cutter. Put whatever spacers you require between the 2 cutters

Question number one, are you on the correct speed setting? ( pulley) Question two, are you holding the start button until it’s up to speed? If yes to both of the above, it’s possible that you have

There are quantity 3 item 20, and 1 item 17 on each end of the hinge. You can move the pivot rod up/down using one pair of 17/20, that’s how you change the hinge side alignment. #24 is only used

We don’t have a C3 on the floor however item 17 is the setscrew used to adjust the infeed and outfeed tables on the hinge side. When I’m back in at work in a couple of days I’ll have a look at

In South Africa, I’m even worse off currency wise than you guys in Australia but I bit the bullet and purchased Brian Lamb’s DRO flipstop, parallel fence and precision square for use on my KF700.