Derek, that¡¯s great that you have something that works for you. How do you do tapers and angles with that wide jig on the end?
Brian, actually simple enough. The stop on the Incra fence slides along the face ¡
All one has to do is run it to the near end. That will provide a very secure nook for the end of the board to be tapered. Further, since there is a stop, cuts are repeatable.?
Of course, if you really want to go nuts cutting tapers, then this is the ultimate fixture for a slider ¡
Article: ?
After turning ...
Brian, the second part of your reply involved finances. I shall post to this in a new thread as it is easier to illustrate with another fixture I built (as I could not justify the costs of a new one). I think that this will be welcomed by those with a similar outlook and need to myself. Later.
Regards from Perth
Derek
?
