开云体育

But you haven’t checked for level…

By the way, the CA functions as a filler, not as a glue. You don’t need to try to force it deep into the split. Jus5 get some medium viscosity material in the gap to fill it near the surface. --

A couple of years ago I laminated a bench top, and had quite a few holes and gaps. It was a rough and ready top made of fir construction lumber, so while I did not have glue-line issues I did have

Ecopoxy is an option without deconstruction

I would run a saw kerf with a tracksaw or very small router bit and inlay a spline the with the matching thickness. If that doesn’t work I’m afraid it’s destined for the trash pile there sir.

I added the surround in this 30 yr old butcher block table for my sister in law. When I received it the table top was already split in 2 near the middle. Now we have another split. What is the best

Greetings Felder Owners. It’s National Coffee Day - the perfect day to remind us all to check the alignment of our espresso machines. :-) David Best david@...

Well, Bill, you already know my attitude about this. Your KF700 probably has an adjustment bolt under the cast iron top between the saw and shaper to counteract the “sag” that is induced by the

David, I did this and found that my table was not flat. I also attached a good straight-edge to the spindle and rotated it around and saw the same thing. I really don’t want to get into the table as

Thanks, I liked the “expensive tools” method. Laughed my ass off as you hit the nail on the head, that’s me allright! Bill Sent: Monday, September 26, 2022 11:54 AM To:

Thanks, I did that earlier and I found that my table was no square or flat. I will be buying the tenoning plate so I thought to make the spindle 90 degree to the plate as that is the point of

Sold, and assuming no problems, payment-pickup on Sunday.

Similar to Mac’s method but with a tool that can also assist in setting your cutter and fence. https://betterleytools.com/products/una-gauge.html

…as well as coffee making ?.

Good update. I'll try to keep it in long term memory. Dave ________________________________ Sent: Monday, September 26, 2022 4:49 PM To: [email protected] <[email protected]>

I spoke to a Martin rep when they first revealed the new J/P and he told me that the old one was built by Griggio like you said. However since Griggio went out of business, they did not sell the TP300

You can clamp a 12 or 18” straight edge between the spindle nuts and rotate in 4 quadrants and bring spindle down and check with piece of paper between table and ruler or straight edge. Re set stops

The attached is right out of the Survival Guide. Attach a dial indicator with mag base to the side of the bare spindle, indicate down to the cast iron top, then rotate the spindle by hand. The spindle

Method 1 - practical geometry method: 1. get an s4s board. 2. face cut board along one side with a square edged cutter like a rebate with shaper indicated at square. 3A. Crosscut board, flip one of

I’m sure someone else will chime in but I would drop the spindle down until you had 1 inch above the table and come at he spindle with a fixed digital gauge and zero on one side then rotate the