开云体育

Imran: My bad, the 5T1 does not show a 208V but the wiring diagram does show a 208V tap (the sequence is 400V, 230V 208 V) the wiring diagrams are Greek to me. Terry

Imran: Year of production 2013, schematic shows 230V …no 208V tap. Brake board has no display window. Agreed on the low voltage…just no one can tell me how to re-set the machine parameters to

Terence, My first guess would be that these voltages being low is the problem. Most digital circuits have low tolerance for low supply voltages. What yr is your machine? Does your schematic show

Imran: The 5T1 does not have a 208V setting, only 230V with the +/-10%. Yes, it will start but not run. The secondary voltages on the right side of 5T1 are low, 20V although in the 30V slot.

Terence, Not sure what year is your machine but mine is from 2011. Because of some experiences, I can share some information that may be useful. First, per the schematic the start function is built

All: I need HELP. I moved my 7.35kw Dual 51 from a shop with 240V to a shop condo with 208V (two legs from a 3 phase utility supply to a single phase panel). ?The Dual runs on a Phase Perfect Phase

Felder K 500 S with 9 ft. X-Roll slider in very good condition. Built in 2012. This is the version with Felder (not Hammer) internals. It has 4HP, 220v, 1 phase motor with a mechanical scoring unit.

Do they ship to the US? Dave Davies -- Dave & Marie Davies www.myfinishingtouch.com 318-219-7868

This was for my older 2001 machine, but the same ideas apply. I went from adjusting every time I moved the fence to checking it once every couple of years, and it repeats on the 24” leg of our

I had the 1100 table on my 2000 CF731. It came with an after market fine adjuster that mounted in the aluminum extrusion of the slot with the movable registration block. I could make very fine

Joe that the place I found also -- Paul Mc Cann

Thanks David. I have asked if it is possible to add the registration feature of the current 1100 outrigger to the older model. Let’s see what I hear back. Imran

That is the older style 1100 outrigger table. It does not have the newer 90-degree registration stops you can see on the newer version in the photo below. It might be possible to order those

David, Here is one the Brad shared with me. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Would you please post a photo of your outrigger table that shows the entire table and crosscut fence. I can tell from your photos that your machine has an X-Roll sliding table, but the components

Appreciate all the help. Upon calling I learned that the part is 213JD, $8520 and actually in stock! So soon on its way I hope. Brad

I called Scott & Sargeant in the UK and queried re: their?Chinese made saw guard; it is designed for sliding tables. They sent me a few photos and I was able to establish that the two rails that bolt

I've been privately troubleshooting with the help of Imran on setting up my "new" 2004 KF700. There seems to be no provision for a squaring fine adjustment for the X-cut fence; the angle indexing rail

Paul, I found this place in the UK that sells Renaissance Wax for a much better price than what is available in the US. There seem to be

Initially I only saw Renaissance available in very small tins which was why I thought expensive. On a further search I found 3l avaialable for ?64 about $80 which seems very reasonable, ?79 ($100)