开云体育

I am having issues with the Utility supplied 3 phase power.? I live in a residential neighborhood and was lucky in that the utility was able to install two transformers on my property to deliver

Joe, are you running a Smart Collector on the Kundig? The extra pull under pressure should be a real benefit. Sanding either wide, or thick pieces are always the problem with a WB. Too little or too

I think you are correct Sent: Wednesday, July 21, 2021 8:17 PM To: [email protected] Subject: Re: Electrical question[FOG] Finally found and purchased my Kundig wide belt sander The CFM in

The Kundig has only one 7” port. Seller had a 5HP Oneida with about 50 ft of duct and in the test before buy dust removal was great. Machine was really clean inside too, and not blown out, I could

I defaulted to 1.25" shaper tooling, and only recently added 30mm bore options in my shop - nope, haven't found use cases that regular groover tooling didn't solve first. But if you had that as the

Mark, my shop is definitely too small for this superb leveling tool ?.

The CFM in the Kundig manual makes me wonder if the manual was written for a two head with two ports and not edited for the single head machine. My 43" two head has two 180mm ports. Dave

Now it makes sense, I thought you were talking about one of these…? Regards, Mark https://www.instagram.com/kessler_woodworks/?hl=en

…just realized the spelling error in the title ???. My apologies. I hate auto insert ?! I am talking about groovers in case anybody has any doubts. J.

Agreed, manual specs don't make sense. I don't know know anything wide belts specifically, but 25HP is a lot of material removal power, and crude extrapolation from saws suggests to me that 4500 fpm

Agreed with the others. Especially if you had motorized elevation/bevel. VFDs are the quickest/dirtiest means of powering a single 3 phase machine, but it quickly goes the other way with more complex

I’ve been running a Phase Perfect for several years, without issue.The cooling fans are audible, to the extent of disrupting music being played. That said, it does the job without drama or

"In electronics, a bleeder resistor is a resistor connected in parallel with the output of a high-voltage power supply circuit for the purpose of discharging the electric charge stored in the power

Thanks to both for your feedback. Do you both use the dado/groover on the saw as well as on the spindle?

Mark, Short answer is don’t do it. VFDs need to be connected directly to the motor. There can be switches in between but they can be left in on position. I use one on RL125 this way. RL switch

Obviously, living vicariously by enjoying what other’s are buying. Waiting for the big reveal ? Imran

Hi Marty, Power up machine while pressing reset button on pad. plane a plank incrementally to 20mm by ignoring display and verifying thickness with caliper. When you achieve 20mm press reset again and

Does anyone run and of their 3 phase machinery on a Variable Frequency Drive off of single phase power? I'm specifically asking for my Sliding Table Saw K940s. But am also curious for other machines.

I think maybe your outfeed table is maladjusted? It should be dead level with the cutting blade when it's at top dead center. On my old jointer, I used an inexpensive dial indicator with a wide button

> > Thank Imran, it’s going to look even better once I get this saw installed