开云体育

Shaper spindles for your machine should be available from Felder. They also come up used fairly frequently. Brian Lamb blamb11@... www.lambtoolworks.com

Yes, dual51 is 4 post table elevation. As you can see the thickness is very close on ends and slightly thicker in middle. I believe a 20” wide board will reflect a combination of 3 runs as, I doubt

Thanks – after I confirm with Joe that this looks similar to what he got and get some pricing I will send a note – then a separate email the individuals who have requested one to get shipping

ok, now I'm just embarrassed. I literally just laughed at my self in the workshop. I pulled the knob and the spindle came right out. For some reason i have just thought of the knob as a spindlelock

Fantastic! Well done research there. And every number on there is within the stated tolerance of .1mm. Maybe a 20” wide board would be over that from one edge to the other, but that is

Hi Shawn, As for the accuracy of planer is concerned see attached. This is just my data and is not designed for communicating to others. Hopefully, you can make sense of it. Feel free to ask any

Hi Michael, I’m guessing there will be some freight/shipping costs associated with this project. My UPS/FedEx delivery address is 2321 Fort Bragg Rd, Willits, CA. 95490. If you use USPS, it is

Jay, You will get better help if you post pics of what you have. If your shaper setup is similar to my 2002 machine (see pic) then spindle removal requires following steps. 1. Pull black handle

You’re right, .785 is the same as 19.94mm, but .785 is the closest the indicator can get to 20mm, and since it’s set up for resetting to 20mm (being made in Austria), I’m thinking that when we

Hi Yes this helps:) Thanks for the swift reply. As I said I live in Norway and the market for used parts is obviously smaller over here. Though getting the spindle made locally vs. getting one

Shawn, Thanks for sharing that calibration also works in inches. I obviously do not know exactly how the SW works, but with what you shared should one not caliper the material to 0.785”, if using

Tom Gensmer - 1 -- Tom Gensmer Heritage Home Renewals, LLC Minneapolis, MN

Imran’s advice worked perfect for my 941. But if you’re in inches and don’t want to switch to mm, you can do the same process and just mill a board to 20mm, checking with calipers, then hold the

https://www.youtube.com/watch?v=SpaRT61GVSg from Bills message: /g/felderownersgroup/topic/shop_tour/83259287?p=,,,50,0,0,0::recentpostdate%2Fsticky,,,50,2,0,83259287

Terence, Please check this out. /g/felderownersgroup/message/115774 Imran

Hi All: I am using rented shop space at the moment. ?The shop has an AD 741 with Power Drive. ?The digital readout is inaccurate by about .020". ?Is there a way to reset the Power Drive to

All: I somehow deleted the YT link for the David Best shop tour…could someone post the link here again. Thanks, Terry

Joe Albiston - 1 Thanks Sent from my communication device. Please excuse any grammatical mistakes. wrote:

Dave Davies - 1 wrote:

Joe – Procap responded and said that this is what they believe they had sent to you for the 1 ?” spindle. Can you take a look and let me know if it looks right? I have only seen the