开云体育

Hey Tom, Looks like you've been busy planning! Exciting times. The first thing I noticed in what you wrote that all the other machines will share a circuit. I personally would advise against that.

If I were looking for an air compressor under 20 hp I would buy anything but Quincy piston type. I have owned several different brands of compressors Including 50 hp screws. Quincy are quite, long

What a fantastic source of knowledge you all are. Brian L, I love this idea.

Thank you for the feedback, The KF700S isn't ordered quite yet, hopefully in the next few weeks. I was planning on the 9'/2800mm, but using the Shop Planner software on the Grizzly website it turns

One 90 degree long radius at either 6" or the 8" would not do much damage in terms of air flow impedance. Doing two long straight runs would introduce more joints, right?

Joe, Your shop and home is fantastic, and that 3D scan technology is amazing. ?Such a great idea by your realtor. ?I think it really shines for this use. ?Good luck on your sale and I am sure you

Nice layout, obviously a lot of thought put in. Similar to Anthony's thread about his addition, the comment about workpiece / stock placement & movement is important to repeat although I think you

Brian, Graph paper and scaled cut outs works beautifully and is what I have done in the past.? In this case I wanted a project to help figure out Fusion360 so granted I went a bit overboard, but it

Sang Luu, There is an additional space I am not showing in this layout that will hold my CNC and sheet good storage and likely longer term lumber storage as well. ? In my past shops I too didn’t

Here's another try at inserting pictures. ?The closeup shows the divot missing from the tire. ?Not sure how that happened. ?I estimate I have under 10 hours on the machine. Regards, ?Vic

Thanks Bill! Not shown is a FAT-300 or FAT-300S I plan on eventually acquiring, and I have two MFT/3 tables that ride around in my Sprinter that I can always bring inside if I need more assembly

While searching for information about hide glue I ran across the following comparison about three types of glue that I thought might be a change of pace for this group. ?this came from Tools for

Tom, Looks like a really nice setup! My only suggestion is that it looks like you need more workspace/workbench/assembly table etc. Bill Belanger

Good day to you! I'm in the process of planning out my Shop, and was hoping to get some input on appropriate dust collector placement, ducting layout, and generally checking out my tool layout with

No picture… but as far as I know you can buy a new wheel from Felder or get them recovered. Others will know where to recover, I bought new. Brian Lamb blamb11@... www.lambtoolworks.com

I was using my A3/41 in planing mode yesterday when I started hearing an unusual noise. ?I removed the inspection panel and saw the rubber (or similar) tire had come loose on about half of the

joe, i may be getting ahead of myself. I’m going to hold off on buying any spray equipment until I have the new space finished around the end of the year. My current compressor is a 20 gallon Quincy

I did that a lot too, this was actually the valve that takes the pressure off the compressor head when it shuts off, so it can easy start again. Completely smoked the wiring on the motors. I even

Paul, So close! Come and buy all my stuff and the building! $2.2 million. Joe in New Orleans

Tom, To avoid buying an expensive Air compressor with dryer system and pneumatic pump to use to spray I bought the Graco Finish Pro 395 air assisted airless sprayer. It is an electric pump with a