Thank you for the feedback,
The KF700S isn't ordered quite yet, hopefully in the next few weeks. I was planning on the 9'/2800mm, but using the Shop Planner software on the Grizzly website it turns out that the 3200 table just squeezes into the Shop.
I'll revisit the Oneida high vac setup. It occurred to me that, in lieu of the 90 in the NW corner, I could run a line along the ceiling to serve the center drop, and serve the KF-700, but my concern there is that while I might save a few lineal feet, I'd be introducing more angles to get up to the ceiling, across the Shop, and back down again. I'm terribly curious to hear what the folks at NordFab have to say regarding how much airflow they think I'll get at the end of the run (KF700), and if they think the RL units will serve my needs or if I need to revisit the Oneida units.?
Ultimately, at this point I'm just trying to identify where I should locate the central dust collector so I can run the electrical, at the moment I'm using a Oneida Mini-Gorilla and just shifting from machine to machine with a 10' 5" flex hose.?
--
Tom Gensmer
Heritage Home Renewals, LLC
Minneapolis, MN
Tom Gensmer