开云体育

Randy, Just a heads up. I struggled with my K915 as it would start to feel a bit “lumpy” and it was the rectangular outrigger bar that needed cleaning not the table. The rollers in there seem to

You will find cleaning the outrigger slide on all 4 sides will help with the smoothness, just don't use any type of lube that dust will stick to. I do this monthly. If you try using an abrasive make

I have used Ballistol? on my Hammer slider for years. It really works, you will notice a difference.. I put it on a folded gun cleaning patch and clean and lube the rails on the slider and chassis.

I do have the standard K500 with the short chassis base, but with the longest slider available for this machine and the 1300mm outrigger and yes there is a block of concrete inside the chassis. Bill

When I was at the Felder office and checking out all the machines, I noticed how smooth the sliding table was on their showroom Kappa 400.? I just glided with zero effort and zero sound ( I'm hearing

Humm, didn’t think of not locking it down I will have to try that but 2 on all the time? Is your slider a 15 footer? I guess I can’t see where it would ever mess up my flow by not using them,

I have 2 parallel guides with the tables, typically on the slider all the time. They are great butt bars easy to move and having 2 is my greatest slider extravagance. They are never tightened and free

If your talking about the handle that you place in the back of the slider on the side to pull it back.? I was thinking of the parallel fence to use for not only supporting sheet goods, but also for

I was thinking the same thing but found the table got in the way most of the time and it doesn’t adjust as easily/quickly as the butt bar. Also the parallel fence and table is like $500 and the butt

I was going to buy the same thing..But when I was at the Felder office in Anaheim, Carl Knapp was showing me the Felder parallel fence that you can remove the gauge and it becomes a longer butt bar.

FYI https://trademachines.com/lots/5df25e2ff5fad211b0e3b488 Imran

Make a custom one to fit you! I never have but every time I cut up lots of sheets I think I should... Eric wrote: Eric J. Smith Trading as W.G. Joinery ABN# 24 079 587 520 03 5784 9258 0411 264 272 PO

Would any one have a butt bar that they don't use and want to sell, I was going to just order it from Felder, but thought I would check here first. Thank You all Glen

David, Lol on that one, But might you have for getting the cow up on the slider. I am having trouble with legs dangling and doing miter cuts. Glen

This is a called cow tipping. https://youtu.be/rmGGlZTjWa0 David Best - via mobile phone

Bill, I was having a private discussion with Michael and caused some confusion. Last year, I was looking at a used K540 and the owner said that it has a concrete block to make chassis heavier. It did

For a one-off, small installation, don't waste your time/money with special tool PEX connection types. Just use push fittings, a la Sharkbite. The special tool systems, like Uponor and Viega (I have

You counter weight the back corner of the machine to counter weight on the outrigger. Fill the floor with concrete. Concrete is 150 # per cubic ft. Also has absorption qualities , I have used it in

There are a number of different types of pex tubing in heating we use aluminum core. martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell 608-824-0023 fax

I do have a K500 but do not have issue with counter balance or do not know I have. Can you explain what do you mean by counter balance issue? Bill