开云体育

My shop mate and I have an RL 140 dust collector that hasn't been pulling its weight recently. I suspect we need to open it up to do some manual cleaning of the filters rather than just the pull bar

Nelson, I don’t believe I’ve seen you post about your intended use or need for a T-nut. That information would be helpful in guiding you. But I think you’re over analyzing this and getting

I put mine on a long pegboard peg. The clamp hooked over the peg, and the fence dangled straight down. Not very elegant, but since I did not use it I did not care. (Now it is on a pallet, as I try to

Parallel guides may be quite helpful, along with a device to set one to match the other. DRO for the crosscut fence stop. If you did not get one from Felder with your saw, the Lamb Tool Works version

John and others, however do you hang the short xcut fence on the wall?

Nelson, AirTight Clamps. https://www.airtightclamps.com/products My second set is due to be delivered in a couple of weeks. PK

I see.? I was hoping to use it more so I won't have that long fence out the side all the time.? Maybe only use the long fence when I really need to.? I should have enough room, but it's still

If you ordered the short cross cut fence option it will come with the mounting bits and pieces. If you are like many of us you will find some way to hang it on a wall somewhere to collect dust. --

Thanks for the info David, this is very helpful. It seems the bushing location on the Felder T nut is just 1 and you have 2 such locations on your design.? I have not seen any of the Felder

For the new saw I'm waiting for, I also added a 900mm crosscut fence, but no mounting hardware.? I was not explained what hardware I needed.? David:? What is the upgrade kit you mentioned?

David:? I watched all these video you posted related to the short fence and how you fixed the problem, it is clear to me what you did and why.? Thank you. I was just wondering, if you made a T Nut

I have an older model, the Ceos, with a 150mm pad. The difference between the Ceos and the Deos is that the Deos comes with the transformer built into the sander, while the Ceos requires an external,

The sliding table and the splinter tongue shown in those drawings is of a pre-X-roll machine circa 2002. Just FYI. That said, the wing-screws and rhombus t-nuts could be used with the current crosscut

Tom thanks that is helpful Get Outlook for iOS<https://aka.ms/o0ukef> ________________________________ Sent: Saturday, December 14, 2024 5:42:23 PM To: [email protected]

Thanks PK Get Outlook for iOS<https://aka.ms/o0ukef> ________________________________ Sent: Saturday, December 14, 2024 6:04:57 PM To: [email protected] <[email protected]>

Netaniel, I went out to check out what I have and I have the answer: These are for a sacrificial piece of wood to be added to the crosscut fence: This is for a sacrificial piece to be added to the

Michael, I have used the SurfPrep 3x4 and subsequently bought and use a Ekasand 3x4 from Uneeda.? They seem to be identical and the Ekasand had a longer warranty.? Prices are the same, but Uneeda

Hi Michael, I have the Mirka 6" random orbit sander and I really like it. With the sander in hand I don't notice the paddle switch. For shop work I wouldn't hesitate to go all-in on Mirka. If you opt

Thanks Jason - I have read really good things about both of them … probably cant go wrong with either Thank you Michael [email protected]> wrote:

I have been using a 5" Mirka Deros since 2020. It just went kaput one day a couple weeks ago. Sent it in for service, they made it a very easy process. Came back with virtually every part replaced.