Thanks for the info David, this is very helpful.??
?
It seems the bushing location on the Felder T nut is just 1 and you have 2 such locations on your design.? I have not seen any of the Felder accessories or the fence, have a few more questions:
- What is the bushing typically used for?? I see you use it for vertical alignment in the videos, I can see how it's used.? If you don't care too much about vertical alignment, like securing a clamp, the bushing is not really needed right?
- Is there a pin on the Felder fence to go into the bushing as well?? I can not tell from anything I have read or on videos.? If the Felder T Nut can not be aligned like your design, then the accessory may not be vertically aligned corrected.
- In you revised design drawing, there is a --1.74mm gap at the edge of top left corner.? I'm not sure what that's showing, is it tapered from the bottom to the top by 1.74mm?
-? Also, what is the "5/8 end mill cutter" note on the left upper corner?? I have not seen much mechanical drawings before, not too familiar with these notations.
?
Thanks,
?
Nelson?
