开云体育

I'm a member of Sawmillcreek.org and a moderator on Canadianwoodworking.com Regards, Rod.

Jay, That's a beautiful machine. Just one thing, wondering if you can talk to my wife and convince her to welcome it into our family? Thanks? Lol,? ?Tom Ruth

Hey! 2022 felder k740 with 2800mm sliding table (xroll) I need som help to figure out what to do about my sliding table. I’ve always gotten a curved cut when straight line ripping sheet goods. But I

Aren’t you measuring the wrong board? Lol. Elwin

Thanks for the photos. As has been commented on before, some people don’t have an issue with the bat ears, others do. That said, my bat ears are bigger than your bat ears. ? ? David Best

Having yet to actually mount the Felder dado set and make some cuts, I figured this would be a good way to do some tests and see for myself the "bat ears". Each dado measures 7mm H x 12mm W I cut some

Hi, I find the following for the 125mm rebate head 1) it fits below the table 2) the radius is small enough to match most furniture requirements 3) there are many bearing type guide rings at, and

If I have a choice I always adjust the non hinge side For the A3 you put a 0.15mm feeler gauge under the straight edge at the far end of the hinge side of the outfeed table the raise the infeed table

This is sold....

Hi, new unused D951 for sale still have the original pallet and foot mount cleats for shipping asking $14,000 firm on that for the moment.? Machine is three phase 7.5hp spiral cutter head still under

I would Criss cross strap to the tunnel under the tables. Hold down the machine with the felder clips and box base to deck with 2x4’s Lock tables down take . cover with plastic and stretch wrap

This has been discussed and debated several times over the years here on FOG. Have a look at the following threads in the archive:

Hello and thank you in advance for any input. I am a proud new owner of a 2012 AD741, not the new body style but the one that the base steps down in width. I have gathered I think on this forum that

I agree with Lucky, the bat ears are visible but I don’t design furniture with exposed dados. Also they serve to make exceptionally clean cuts.

Glad you got it working! Brian Lamb blamb11@... www.lambtoolworks.com

Hi Murray: Very kind of you to say that. I do not find the bat ears to be a negativity and therefore have not tried to “hone them down”. They are big enough to see, for sure, and in fine furniture

Well, I reexamined my work and found several faults. First, Mac was right. The infeed table was clamped much too tight. Second, I determined that the bolts on the hinge were too loose, causing the

They are a beautiful detail that u can see with a magnifying glass. Allows you to cut in x and y that’s the beauty. Mac,,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi

I’m just wondering if there is any consensus on the significance of the “bat ears“ issue? Lucky, you do fine work, do you find this to be a problem? Has anyone honed ?the nickers, if so, how do

Hi guys Just my two cents. I am fortunate to have a very large shop with cathedral high ceilings and mezzanines for storage. During the planning stages I knew that I needed some lifting equipment to