开云体育

Brandon, My machine is 2019 kf700sp - the back round plastic handle at the end of the slider is packed with the buttons and 2 wires go through slider, a hole in the chassis, and a couple terminals on

Brandon, Check this post /g/felderownersgroup/message/114241 If interested, I can send you the details I shared with Stan Blaszczyk. Imran

It shouldn't be to hard. The start button should be wired parallel the stop button in serie with the others. The switches and the required gateway are quite expansive. I believe there recently was a

Is there any way to determine what options are available to retrofit a machine with the remote slider buttons? Mine has the belt driven scoring blade so I only need one start button. Stop probably

Thanks Marty. I guess, I am wondering if I have a code as well. Will figure out thru felder. Imran

Marty, Glad that worked for you! Interesting that your dro just shows the number. I figured U 2.1 was a software version but perhaps it is an error code? I'll have to contact felder support and

My dro doesn't show any codes on power up.? It shows the same number on power up as it did on power down. Cheers, Marty

Hi Marty, Glad it worked for you. Do you recall what your display shows upon power up? Imran

Sorry it took me so long to respond.? I followed Ameer's directions because his display looked the same as mine.? Everything worked fine except the reset button doesn't always "reset".? It's a bit

Mike, Please share the wiring diagram. Without that here is a generic response. If your machine is single phase check the start caps. Make sure all safety limit switches are inactive. Either way, 1P

Here is a link to an Abilene, TX Craigslist with several large woodworking/metalworking machines including two large bandsaws. Other than posting this Craigslist link I have no knowledge about any of

ahh man! I was hoping to buy it for a dime.. thanks a lot!! LOL

Many thanks to David, Imran, Brandon any everyone else who responded. Apologies for the late reply, but I put my back out while I was unloading everything? (ironically, reaching for a small piece of

Thanks for the replies, it took a pair of pliers to break the knurled screw free, all is good now

I just received my Quick Lock shaper cap (thank you again Michael Marsico!), the instructions that ship with it explicitly say to NOT touch or loosen the slotted set/grub screw. You should be able to

Great info Andrea questions. Can’t wait to get over there and look at the unit to see what accessories are there. Will definitely send more info when I have it. Can’t thank you all enough for the

“Going out on a limb” because I don’t know for sure… Regards, Mark https://www.instagram.com/kessler_woodworks/

Going out on a limb here to say no, i though you just loosen the hex Regards, Mark https://www.instagram.com/kessler_woodworks/

Does anyone have the Felder Quick Lock. I ordered it with my new saw but I can’t get it to loosen, does the red screw need to be removed, I tried to loosen it but it won’t budge.

Hi all. Probably simple fo someone who knows more than I do: Over the years, occasionally I’d turn off the saw with the small red button (not the emergency twist knob ) and then the saw wouldn’t