开云体育

I have the power drive option on my K700 shaper, my Exact 63 planer and electronic screen controls on my Kappa 40 table saw.? I can honestly say I don't know what I would do without them.? Not only

Hi Mark: I can speak to your questions in relation to my Kappa 400. It does hold its calibration. Amazingly so. These power options increase my productivity, and put a smile on my face. I do have to

Thank you for the quick replies and info. Brian

K975 manual says to grease the saw height guide every 40 hrs or monthly. It does not mention/recommend a grease type. I have grease for the shaper spindle in the gun. I forget what it is but it was

Around Madison wi a re wind 1/4 or 5 hp is 500.00 I would change bearings also! Mac,,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell 608-824-0023

It’s a standard motor, so any motor repair shop should be able to handle it. It does have external capacitors though, so I would have those checked as well. Brian Lamb blamb11@...

I have been a member for several years but rarely post, usually on every day however, observing threads. I have a 2012 F700z, single phase. Yesterday, while operating the machine, I starting to smell

Still available?

Question, how great is the full power drive option on a saw, say k700 or k900? Worth the money? I could see the benefit of dialing in an angle other than 90deg or 45deg quickly and dialing in a

https://phoenix.craigslist.org/evl/tls/d/mesa-felder-cf-731s/7124902153.html Imran

Anyone interested in buying this hold down clamp? I got the Airtight clamps from Mac and no longer need this clamp. $125 shipped.. ( US only) Send me a PM if interested..

OK, I understand better now. Does Nordfab make a 30? ell? Put a 45 and 30 together at the wall to ceiling by the DC, that’s within 1? of your 106? (16? more than 90). Do a fitting close to the

Hi Joe, No shag carpet o well. Custom elbows , two barrels under The cyclone if you have the height. Mac,,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106

If it is not hardened steel? try? heat.? If it is? try less heat.? but? first apply? some wintergreen oil (not the synthetic stuff). ? that's the old school aircraft mechanics? penetrate of

Here are a few pics of the mess. The pipe will go up from the right side of the pics, follow the ceiling until a horizontal can clear the HVAC duct and go to the other side. A branch will run each way

Good idea, might have to try that. Brian Lamb blamb11@... www.lambtoolworks.com

I have one connection that I swap out with another.? I understand the? knurled knob? you have there.? My? way to skin that cat was to use pop-rivets to put a ring of sheet metal inside one of the

I’m sorry it was canceled. I’m sure there were more reasons than those stated for the cancellation. I suspect both the attendee enrollment was way down, and the number of exhibitors was also

You got lucky, usually once they start to gall, you are pretty much done for. =============== Brian Lamb blamb11@...<mailto:blamb11@...> Phoenix, AZ ===============

It was probably me not tightening the spindle rings enough and it caused the spindle’s metal to get rough where the cutter was located. The ring was getting stuck there. After getting the ring off I