开云体育

My dream has come true - embrace the picnic hamper option: https://youtu.be/x58SHdutQr8? Felder Lifestyle Options - the latest edition to Format 4 youtu.be “You can use it functionally, but

Also, if you are getting a shaper and are new to shapers, I highly recommend the Alpine Workshop in Colorado.

Congratulations, Stan My shop is more than a 2 car garage in size at this time. ?When I was limited to 2 car garage, I found it very cramped even with a Unisaw (I have a slider now). ?I see others

Wow, what a ride! Congrats on the purchase, I'm sure you'll love it. Best regards, Mi?elis Vindavs wrote:

Congratulations. I started with KF700 and 2m slider. You will love it. Shaper is an amazing tool and full of possibilities. Imran Malik IAM Wood

A little update to wrap this thread up. After deciding to go with a short stroke B3 I have discovered that a custom order would not be ready until October. That was not ideal for two reasons. One, I

Joel, You’re a much wiser and smarter man than I am :-). I sold the 500V and then regretted it and recently bought its replacement Vakuusyst-S. ?Just to be clear, it’s also quite amazing and

I would just go with alarm. Shutting blower mid planning will make a mess. Imran Malik IAM Wood Creations https://www.facebook.com/groups/362481112015700/?ref=share

Rip fence. Thanks for the clarification.

When I automated my dust collector I put a sensor in the circuit that shuts off the blower and sets off a tone, it is at the wirenut level of technology. Everywhere at $60 and sometimes $45. Now I

I have a format 4 fence with micro adjustment, the rip fence and 50 mm bar if you’re interested contact me off the fog Mac,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi

May want to clarify, Rip or Xcut? Imran Malik IAM Wood Creations https://www.facebook.com/groups/362481112015700/?ref=share

I am looking for both a BF6 fence and a 700s fence. Used or aftermarket. ?All suggestions welcome! ?Many thanks. ?Rhett Jeppson

The suction idea is very interesting. I can experiment with that. I will also do other checks on the alignment. This version of the saw does not have a typical throat plate. I believe this is due to

In addition to David’s thorough response, I’m just confirming that when you perform through cuts you have your saw blade raised enough so that only a minimum of teeth is engaged in the material

It could be that the suction of your overhead guard is pulling the off-cut upward and into the blade. Or it could be that the throat plate supplied by Felder does not have tight tolerance to the

David, I am not getting burn marks on the off-cuts. I am using a SilentPower 30-tooth Universal blade (model 03.02.35030). I am using a roving knife, and I believe I have it installed

Do you get burning on the off-cut side (to the right of the blade) if the material is clamped down to the slider? What blade are you using and do you have a rivving knife installed and properly

I am about to re-check the alignment of the slider on my saw. I thought I had it pretty well tuned up, following the David Best videos, but am seeing some unexpected behavior. Small offcuts tend to

It appears to be the same technology as used in my Oneida device. Price point is similar. The issue I have had with mine is failure to keep the sensor clean. Other than that I have been happy with