开云体育

It could be that the suction of your overhead guard is pulling the off-cut upward and into the blade. ?Or it could be that the throat plate supplied by Felder does not have tight tolerance to the blade, and the off-cut being so small starts to lean over into the blade. ?Both of these situations can cause a small off-cut to get caught by the back of the blade and thrown forward. ?I had this problem on my Kappa 400 and it was all related to the throat plate, so I designed a replacement ZCI throat plate, installed that, and the problem stopped. ?The OEM throat plate on these machines is typically angled on the right to accommodate a tilted saw blade, and that angled section would encourage small off-cuts to tilt over and into the blade causing a kickback. ?You can see my ZCI effort?. ?I believe someone else here on FOG makes a 3D printed version of something very similar to my design for the Kappa 450.