I am about to re-check the alignment of the slider on my saw. I thought I had it pretty well tuned up, following the David Best videos, but am seeing some unexpected behavior.
Small offcuts tend to fling back toward the front of the saw. If I trim 1/8” off the end of a piece, for instance, the off cut will often fly clear off the saw.
?
Does this behavior give me some clues as to the slider alignment? Is it telling me I have too little toe-out, or maybe too much? I’m not burning the off-cut.
?
Thanks for any advice!
--
John Hinman
Boise ID
Kappa 450X and A941
