开云体育

I just about to make my airline and hotel reservations when the notice came through. Bummer?Take care?John.?Sent from my Samsung Galaxy smartphone.

Joe, The Nordfab custom elbow has very little flexibility during installation as far as changing the angle is concerned.? I chose this option when I ordered by ClearVue cyclone and Nordfab duct.? I

I built this back in maybe 1997, so it was pre-Thein. I’m sure I could improve on it, but it’s one of those things that you’ll always plan to get around to and rarely do. Brian Lamb

There were some huge logistics issues with European exhibitors, too - did not help the case. Looking forward to future shows and a real shame to wait two more years for this one.

Interesting on the garbage can separator I thought it might be a Thein design at first look. Used the Thein design on Shopvacs for good separation years ago. The filter was kept clean vacuuming

For those trying to decide whether to go to IWF in Atlanta this August ?you choice has apparently been made. Woodworking Network reports that it has been canceled. ?Hopefully, we can still look

I built the garbage can separator for the drum sander. I welded a rolled flange into the lid, added a cross beam and center bolt sticking down to attach a Cleanstream Hepa filter. Shortened a 5 gallon

Agree with Brian G on his points about rolling offsets - I have employed them with my Nordfab kit and they are a bit shorter and a good bit more efficient in terms of loss versus sticking to strictly

So, curious minds want to know, what was the issue? Brian Lamb blamb11@... www.lambtoolworks.com

Thank you for your comments. They’ve been helpful. I finally was able to remove the ring.

Finally getting to the Plano press. I think I see Brian’s installation is where press is not sitting on the floor but Stuebgen’s appears to be on floor. I have baseboards that stick out from wall

The only time I see anyone use the Esquire title are spammers out of Africa. -- Bill Hope ( https://dnisw.com ) -- Measure it with a micrometer, mark it with chalk, cut it with a Hammer

Google “pipe offset” and “rolling offset”, and there are calculators. With 45s and 90s you can make any angle you need, just “roll” it. That’s a 45 degree fitting that runs at 15ish into

Nordfab has flexible pipe sections, not just rigid pipe. I think they are a bit more costly than a comparable length of the rigid Nordfab piping. Check their website to see if any of their flexible

This is a drop I have kind of in the middle of the shop. I use it for my bandsaw and my drum sander, so I use a Nordfab rolled flange on all the pieces and I can quick change from one tool to the

I would be interested in seeing pictures of what you mention above.

I am going to do a quick sketchup. It’s not like that, the way it will be laid out. Because of overhead doors and the footprint of the shop the collector is on one side next to a 9 ft wall and I

I assume you are running the main branch down the middle at the peak of the ceiling? Standard Y’s should get the branch running down the slope of the ceiling, it’s when you want to come off the

Right. You plan on the long runs where you can use the slip adapters Bill

Joe, without seeing a potential layout it's extremely hard to offer advice but in my delusional mind and see a solution that only relies on ready made pieces using tees and large radius elbows. No