开云体育

Hi, Does anyone on here make the adapters that slide into the track of the K940 sliding table so I can mount a festool clamp into the groove? Thanks! JP

? David Best DBestWorkshop@... https://www.flickr.com/photos/davidpbest/collections/ https://www.youtube.com/@David_Best \

This is what tech support sent to me. The tech indicated that 36 was the macro adjustment and the hinge screws were micro adjustment. Even after loosing the 4 bolts below the hinge and making

Do we have a method of private conversation on this forum? ie can you email me so I can contact you directly? regards, Rod

US. I’ll be back in the shop on Monday. I took all the plates off so it should be pretty easy to get to. wrote:

I install the bottom cutter with a 5mm spacer underneath to accept the pin, same above the top cutter. Put whatever spacers you require between the 2 cutters

Question number one, are you on the correct speed setting? ( pulley) Question two, are you holding the start button until it’s up to speed? If yes to both of the above, it’s possible that you have

There are quantity 3 item 20, and 1 item 17 on each end of the hinge. You can move the pivot rod up/down using one pair of 17/20, that’s how you change the hinge side alignment. #24 is only used

We don’t have a C3 on the floor however item 17 is the setscrew used to adjust the infeed and outfeed tables on the hinge side. When I’m back in at work in a couple of days I’ll have a look at

In South Africa, I’m even worse off currency wise than you guys in Australia but I bit the bullet and purchased Brian Lamb’s DRO flipstop, parallel fence and precision square for use on my KF700.

Thanks Derek! Wade

Hi Wade Can you clarify what you are asking? Are you referring to something else? Possibly this? http://www.inthewoodshop.com/Powered%20Tools%20and%20Machinery/ParallelGuideForK3Slider.html Regards

David Best, You forgot to attach the link to place an order. ? Thx. Wade

Chris, I did include the important dimensions in the descriptions above. That should be enough to go on. Fittings differ not only between countries, but also from store-to-store, so I leave it up to

And let us not forget that for the true aficionados among us, there is always this - complete with DRO and micro-adjust. ? ? ? ? ? David Best DBestWorkshop@...

Derek, Did you say you had plans for your parallel guide? While I am in the US, not OZ as you say, I too cannot justify or afford Brian Lamb’s wonderful tool. I have a Hammer C3-31 and your parallel

Brian, I think Derek sums it up and details the costs. I think you supply a wonderful range of products but for most woodworkers in Oz they are simply not value for money, that is not your fault or

Derek, Can you send you parallel version again? Didn’t see it. Thx, Wade

Hi Derek: To quote your final line: “Again, this is not about Brian; it is about what some (like myself) can realistically spend before my wife kills me! :)” Got it! And understand! Have a good

Lucky, I reply here for clarification and not for debate or to criticize. ?You should know as well as Chris and I (since were are all in Oz), that the shipping costs are a small part in importing