开云体育

In about 2004 I purchased a copy of the "Felder Unofficial Survival Guide" . It's been in hiding in my shop since I moved about six years ago. I sold my BF631 when I moved. However, I buying a Hammer,

Google betterly unagauge Dave Davies [email protected]> wrote:

Dave just for reference all my 2011 F700Z spindles 30mm, 1 1/4" and the router spindle have zerks. I think Felder went all sealed bearing for shapers and JPs around 2015. When I was in the trade we

I spent some time today fussing with fine adjustments on the shaper to get the cut just right with too many test cuts. ?I the remembered the Aigner Distometer. ?Did a search. ?Saw a comment that

It might be that the zerks are only on the router spindle as those bearings need to run faster. I can see the shield in the first picture. For those that replace those bearings, an incandscent bulb

Joe, If nobody has spoken for the two tenon cutters...I'll take them. Thanks, Dave Davies wrote:

Joe, I would like 100 - 150 feet of the Cocobola. Is the wood a mixture of thicknesses? I’ve actually got a little 4/4 and some 1 3/4” turning stock. I’m about six hours from New Orleans so

I do not have such tools and the arbor press, no interest in acquiring those tools. I for sure will get a professional to replace the bearing when the time comes. James wrote:

The special castle nut socket/wrench and the 2 pin wrench will be the most expensive part of the job.?JohnJMK Services

David, I am not going to remove the bearing. My point is the spindle bearing on my 2017 KF700S is sealed and meant to be replaced after a few years. James [email protected]> wrote:

I’ve been down this spindle bearing path before. At least in my experience, the bearings were pressed on with a slight interference fit. You could use a bearing heater to expand new bearings enough

There are two bearings in the 1 1/4" shaper spindle. I do not think you can use a grease gun to pump the grease into it, cause there is no zerk. I think the top bearing can be removed after unscrewing

Joe, I would like to get the PC stapler and Dewalt compressor. I can come by on Wednesday. Paul in Metairie ________________________________ Sent: Monday, July 27, 2020 4:22 PM To:

Joe, I received your private email and you are first in line for the CF731P. I will break up the cocobolo. but no less than 100 bd/ft. I will also send photos of the cocobolo as the low price is

Mike, If it is not on the list it has already been sold. Joe in New Orleans

Hi Joe, Hope all is well. I will take the CF731 and a couple hundred board feet of the Cocobolo (if you end up breaking up the lot). Shiping would be to Maryland. You can email me at jkurtz505 at

Joe, are you also selling your Aigner equipment? I’m potentially interested in your back fence for the shaper… Mike

Hi Joe, I’m interested in the lift and slide cutter, maybe a couple others as well. Email is:shawnkammerer@..., hope all is well.

Joe, hope you are ok. Can you send me details on the Shaper and what’s included? Sent: Monday, July 27, 2020 2:23 PM To: [email protected] Subject: [FOG] Joe in New Orleans is selling

All, I am selling my shop and moving out of my building. ?For those of you who don't know I made European style doors and windows, tilt and turn windows and rebate doors with Anuba type hinges and