开云体育

Again I thank you David Best & "Lucky" and everyone one else that has given me input to help me figure out the Kappa 400 X motion. I am going to make my fourth trip to Felder Sacamento on Tuesday to

you can also consider contacting commercial shop to see if they will plane/sand the slabs flat for you. Mike

Glen you have to create an account (its no cost) and logon to the eshop and you can see the prices of the accessories. Acie J

Thank You! I Know I saw it somewhere, I like the idea, Possible out feed extension on the rip table and out of my way when I don't need it> Go figure its prob. not an option On 400 x Motion One thing

The 2014 Felder Catalog shows the swing away outrigger as an option for the Kappa 550 saw. See page 22 or http://maschinen.felder-gruppe.at//uploads/machinedetails/mdt_img_528_2_162.jpg

Brian, That's it. I would definitely like to follow your process. I will start Looking for the Unifence. Can I send you an email or call you? BTW I am in Greenville SC Dan

Thank You Lucky, This help from you is so much value to me as I try to finalize my machine. at first I was not going to get the outriger cart but I think I am. I plan to do a lot of straight linnig

Thank you David, This makes it way more easy to figure out. Let me study this and the schematic for a bit Glen

All I can tell you is that every dealer says the other cars are worse for repairs. I've always been lucky but if you watch videos on how these cars are made and the amount of electronics stuffed in

It looks like this thread is hijacked towards cars. I am in the market for a car and the new Audi Q7 has very good test reports. Do any of you have experience with Audi that is relevant to their newer

Hi Denis, I gave not played with it but I would start with mounting thd accelerometer on the motor housing. I assume most of the motion would be along the rotational axis. If accelerometer does not

I started this a while back. I took down a norway maple tree on the property. This is made from that tree. There's a forced hot water toe kick heater on it's on zone with a wireless thermostat and I'm

One last digression as well. The new 7 series BMW is a really nice ride. In a year or two it would have been on my list as they are taking a beating on the used market here. Seems they were expected

Glen: David references me with regard to the x-roll outrigger, so I thought I would add my vote for that option. It is exceptionally desirable and I love that feature. I’m perhaps a little stronger

HI, I have a 2000 C3-31, a combnation machine. I love that machine, but the rip fence and the mitre gauge were not usable, at all, I replaced both. If you have a similar machine the fence rail primary

After my last post i though i should had mentioned i have never driven or owned a Mercedes Gullwing or AMG anything of that caliber. Maybe i just dont knw what i dont know? I have been in many top of

There are multiple James answering this thread, but I have the 173, nothing digital on my saw, all cursor and eyeball settings. Sent: Saturday, December 3, 2016 10:17 PM To:

Certainly possible. The Arduino world has lots of breakout boards for wifi and bluetooth, and replacing the wires with these devices could be slick. I'd set this up so each machine has a unique

I would agree with John as long as you can see with magnification as the sacles are you will be with in a few 10 ths of a mm.?It real comes down to being a precise builder.You can have all the fancy

Felders scales and angle marks are extremely accurate on the no options fences and outriggers. If you have an issue with understanding fractions or have bad eyesight then I could see a need. The