开云体育

If you live in a part of the world or US where you always have nice 70
degree weather, you won't need this tip.
Here in Texas, we have 100+ summers and 32-winters. My '97 EVC gets
very uncomfortable in the summer and in the winter the heater cycles
continually.
I've discovered a simple and inexpensive way to insulate the Pop-Top
for either climate situation. A material called "Reflectix" is sold in
home improvement centers like Lowes or Home Depot. It comes in rolls of
various sizes (for EVC's you'll want 48"wide x 25 ft.). It is the same
material that windshield sunscreens are made of; ie. a layer of thin
bubble plastic coated on both sides with 'silvered' plastic.
I cut two long triangle pieces from the roll which exactly match the
side measurments of the pop-top (about a foot at the narrow end and
3ft. at the wide end) and wrap half around the front. These two
triangles of Reflectix are pushed up under the pop-top overhand and
fastened with velcro strips along the base of the pop-top canvas. The
front halves overlap slightly.
Once in place (it only takes a couple of minutes to install when
camping), it insulates the inside from heat gain or loss. You can sleep
much later in the morning with the sun blazing.
The Reflectix triangles can be stored folded once in the upper bed
area or rolled and stored behind the rear seat, or any number of other
places. The Reflectix is waterproof and storms and rain don't bother it.
Kent Kirkley
'97 EVC
'86 Vanagon
'81 Vanagon
'74 BMW 2002
'95 BMW M3
Dallas, Texas

I posted this question a week or so ago and got no responses.
I asked for and received (from Winnebago) a high altitude kit for the
Norcold fridge in my '97EVC but haven't installed it yet. It appears
that a new hole must be drilled in EVC exterior sheet metal below the
current vent and the new vent will be placed right where there is an
indented seam running down the side of the EVC. Is this the case and
how is the new vent sealed if it installs over this seam???
Kent Kirkley
'97 EVc
'86 Vanagon
'81 Vanagon
'74 BMW 2002
'95 BMW M3
Dallas, Texas

kgkirkle-@... wrote:
original article:

When traveling on rough roads (paved or otherwise) my '97 Eurovan
Pop-Top makes a lot of noise as if it wasn't locked down. I'm always
very careful about how the pop-top fabric is folded and that the
pop-top is latched. I think some of the noise may be coming from the
bed-board rattling overhead.
Has anyone else experienced this and how did you treat it???
Kent Kirkley
'97 EVC
'86 Vanagon
'81 Vanagon
'74 BMW 2002
'95 BMW M3

A hearty thanks to everyone for your responses.
I love hearing all the solutions you guys have for this pop-top rattle
problem.
It would be neat if someone were to publish a manual of user developed
improvements to the Eurovan Camper, covering all aspects.
Kent Kirkley

Jim,

It sounds like you have some extra "play" in the front latches. If so,
rather than use the tennis ball fix, it's real easy to tighten the latches
slightly. Without the tennis balls, close the top and check the exterior to
make certain the rubber seals aren't too tight against the metal roof to
prevent tightening the latches without damaging the rubber seals. Try
pulling down on the roof to see exactly how much "play" there is in the
system. Then, to tighten the latches, simply open the roof, loosen the
retaining bolt on each of the latches and rotate the L-shaped catch one turn
and retighten the retaining bolts. Check the roof again and if necessary,
take it down another turn, but check each side separately since both sides
may not be equal.

We found it took a couple of turns on one side and a single turn on the
other to level the roof and provide a secure fit of not only the latches,
but also for the rubber seals to fit properly against the roof of the van to
provide a weathertight seal. The adjustment only takes a few minutes -- its
real easy to do.

Sheldon
'97 EVC

Hello to all,

Many thanks to all for such kind words and encouragement. I'll try
some of the spots on the i-net that Eckhard suggests. I visited the
dealer today dropping off a list of maintanence done to the van (oil &
coolent change intervals, etc). What I was told is that the regional
rep likely won't help since in the dealer's words, "If he does it for
you then he'll have to do it for everyone." I would hope that VWNA
would if everyone took such good care of their engines.

I'll keep you all up to date on what's happening here in paradise!


Cheers,

Doug Shrum
Washington State

Hello to all,

Many thanks to all for such kind words and encouragement. I'll try
some of the spots on the i-net that Eckhard suggests. I visited the
dealer today dropping off a list of maintanence done to the van (oil &
coolent change intervals, etc). What I was told is that the regional
rep likely won't help since in the dealer's words, "If he does it for
you then he'll have to do it for everyone." I would hope that VWNA
would if everyone took such good care of their engines.

I'll keep you all up to date on what's happening her in paradise!


Cheers,

Doug Shrum
Washington State

My '93 EVGL has a noisy knock/rattle coming from under the passenger
floor. It usually doesn't start until the engine is warm, and then
only seems to happen at idle and on deceleration.

I've inspected the exhaust system for any obvious signs of the rattle
and can't find any loose components. Is a rattle like this a classic
sympton of the catalytic converter going south? If it is, are there
any fixes available other than replacing with the factory part (over
$1000 here in Canada)?

Thanks,
Andrew Ebbern
Calgary, Alberta

mdekker@... wrote:

chris noeske <chris-@...> wrote:
original article:

<<The above is one big reason I am GLAD and RELIEVED I no longer own

any

Volkswagen. >>
So why bother reading about something, you neither own or like?

My guess is he's what occasionally pesters usenet groups, a troll.

Usually best to ignore them than start a flame war. Remember the PhD
from back east.

Matt,

I guess I could ignore your comments above, but I would like to respond. To
make a reference to the Herr Doktor was, in my opinion, a pretty low blow,
and uncalled for.

I do not know the definition of a troll, and don't really care to know. If
my remarks seem to "pester" you, I am sorry, you have a right to your
feelings. There was absolutely no intention on my part to start a flame war.
What are your intentions?

I do not see any profit in labeling.

Here's to hoping we can all continue to have open and honest dialogue,

Wade

jmf@... wrote:

chris noeske <chris-@...> wrote:
<<The above is one big reason I am GLAD and RELIEVED I no longer own any
Volkswagen. >>

So why bother reading about something, you neither own or like?

Ditto that, and for the dig at the warranties.

It may have sounded like a dig at the warranties, but it was meant to
inform. If enough of the members were not particularly pleased with the
shorter warranties, they might speak up to VW, and VW might do something to
change the length of the warranties. Everybody would benefit.

We're all entitled to
our opinions.

Thank you.

I don't think Wade will find much sympathy here for his.

I am not looking for any sympathy for my opinion.

I think most people here and in the multitude of other VW groups
participate because we've
had ownership experiences where reliability and value have far
outweighed the occasional consternation over glitches in design or
parts availability.

This may be true, but for me, the glitches became too expensive for my
wallet.

I see more old VWs still on the road than most other makes.

I do not know where you live, but in the Nashville area, I do not find this
to be the case. I would say I see more old Toyota's and Honda's.

No one is immune to problems, but I think we do better than others. I
know I have.

I am glad you have. Yes, you certainly do better than the American makes,
but I think the Japanese have the upper hand. I know a lot of other people
would agree.

Wade

Chris Noeske wrote:

<<The above is one big reason I am GLAD and RELIEVED I no longer own any
Volkswagen. >>
So why bother reading about something, you neither own or like?

First of all, I am not just reading. In case you have not noticed, I have
tried to contribute positive info to help the other members.
True, I do not own a VW now, but who said I do not "like" them?
I said I was glad and relieved to not "own" one now. I still like VW's in
several ways. The Passat is one of the best cars in its class. The VR6 and
the TDI are fantastic powerplants. The EV is arguably the best van on the
market. I still miss the functionality of it. But I do have serious problems
with the attitude and performance of the VW organization (which appears to
be, if you have not noticed from other members too, "We don't care, and we
aren't going to do anything about it") The local dealers here leave
something to be desired in several ways.
I very simply came to a point where I was not willing to take the risk
anymore of incurring large amounts of money and being without a vehicle
needed for daily use. (After only 3 years of use, the $1,500 A/C system on
my '90 Vanagon blew, VW offered not one penny. After only 3 years of use,
the $2,250 A/C system blew on my '93 EV, and only after much wrangling did
they offer to pay 1/3. I "only" had to pay $1,500. Then the shifter bushing
broke and I was "only" out the EV for six weeks. After a lot of time and
effort spent to get the remaining part myself from Germany with the help of
friends, they finally agreed to reimburse only the $70 to ship the part.)
How would you feel to be without a daily driver for 6 weeks?? I missed my
vacation that summer because of the failure to get necessary parts.
I spent extra dollars for my wife and 2 of my kids to fly to New York. So I
was able to use her car for 2 weeks. After that I was fortunate to have just
purchased an old Toyota Tercel that my son would soon purchase for his first
car. I was lucky to not have to rent a car. I do not think it is reasonable
to have to rent a car for six weeks, waiting on a $6 part. If the EV had
been an extra vehicle for me it would be a different story.
Are you going to begrudge me because I prefer a reliable, cost efficient
vehicle?

So why do I bother? Because I think I might be able to help with a piece of
information from time to time. And I can learn about different things from
the members here. I, like, Ron, think freedom to have a diversity of
opinions here is a good thing. My hope is that no one will be offended, but
ultimately we all choose how to act or react.

Peace,

Wade

Hi all,

Our cruise control works, but doesn't seem to hold speed without
"wandering" up then down. It is not dramatic but very annoying.

Is there an adjustment one can make to fine-tune and hold cruising
speed?

Thanks,
Tim

tim.s.cole@... or coltm@...

Try Tomcat Auto Parts @ , they have a
couple of Eurovans, one is a diesel. They deal in used blocks now and
then.

strgcard@... wrote:

jm-@... wrote:
original article:

Does anyone have: (a) an explanation for the pricing on spark plug
wires for the VR6,

Try







These are my favorite sites.
Good luck--I paid $79 for wires for my 93 5cyl.
Eckhard

jm-@... wrote:
original article:

Does anyone have: (a) an explanation for the pricing on spark plug
wires for the VR6, or (b) a lead on a supplier of quality parts who
didn't get the memo about price gouging? I figure this engine should
be in at least several hundred thousand vehicles worldwide now.
There's got to be a better source than what my mechanic has turned up
so far.

Joel Funk
97 EVC (30k miles)

Joel,
Try Mark at Adirondack Motors(sp?). His e mail is
mark@...
I just bought a catalytic converter for my '93 EV MV for less than half
of what VW wanted. I previously bought plug wires for the 5 cylinder
from him also. If I remember right, they were $59 (original Bosch).

Rod in west Texas

This may be a naive question but I'll ask anyway. If one were to lunch a 5
cylinder engine, could you replace it with the VR6?

John Coleman
93 EV WK

Wade,

Good job keeping a level head and avoiding inflammatory statements. My hat is
off to you and I for one, am glad you are participating in this group.

Thanks,
John Coleman
93 EV WK

Does anyone have: (a) an explanation for the pricing on spark plug
wires for the VR6, or (b) a lead on a supplier of quality parts who
didn't get the memo about price gouging? I figure this engine should
be in at least several hundred thousand vehicles worldwide now.
There's got to be a better source than what my mechanic has turned up
so far.

Joel Funk
97 EVC (30k miles)

Andrew,

I had an exhaust rattle from under the passenger seat of my 93 MV. I
discovered that the heat shield between exhaust system and floor pan had come
loose. I reattached it with a drill and pop riveter. It was in an awkward
location and I was very glad I had gotten the kind of pop riveter that works
straight ahead as well as 90 degrees.

Good luck finding your rattle source,
John Coleman
93 EVWK
Boulder, CO

apparently he has quite a nice porta-potty...
;-)

Two tennis balls (we used green ones), one in each front corner of the roof
when closed. That's what worked for us. No more rattles from the pop top.

Jim
95 EVC
S. Arizona