开云体育

Are they serviceable? Can worn turn/light parts in my old switch be repaired from parts in a new one without cruise? Serge

Used will be your only option. Discontinued long ago. If you don’t need cruise control (or it no longer works anyway) the non-cruise one is available new. Ron Salmon The Bus Depot www.BusDepot.com I

I need a new turn signal switch/stalk for my 2001 Eurovan camper with cruise control. Anyone know where I can get one? No more from VW and everyone seems to be out of stock. For example:

This definitely sounds like a CV joint problem.? The boots could look fine but the joint or joints could be bad.? I'd put the van in neutral, raise it off the ground and manually turn the wheels and

Kent, Are you saying you put them on a tintop (non pop-top)?? My concern is not knowing where the ducts, wires etc. run in clg. thx a

Hi, Any codes on the Scanguage ? Could be what we call ‘limp’ mode. This happens when a transmission gets too hot or if some solenoids around the valve body are defect. The van, then, starts

Yep, I got under the van, removed cover and checked all joints, everything is sealed. Both sides resist, click and snap when turning wheel left or right. Steering wheel is very lop sided forcing left

I used the Yakima Tracks with the Plusnuts (rivnuts) on mine. It also looks like the Landing Pad 21 is a screw into place option.

Yep, I got under the van, removed cover and checked all joints, everything is sealed.? Both sides resist, click and snap when turning wheel left or right. Steering wheel is very lop sided forcing

Get down with light and look at cv joints

Have newly installed axels on the past year and new rebuilt transmission in 2019. No leaks anywhere. Just had a flush. Van drives straight just fine, turning makes a click noise and the tires

Sounds like a problem with CV joints- could be tranny- but sounds like front CV joint problems I've had in several VW's and AUDI's over the years. Start by looking at CV joint boots to see if they are

Also noticed now after stopping that steering is difficult, also van moves forward by keeping steering forced straight, but if wheel is turned in either direction the wheel jerk and click.

Help, any advice on what could've happen. A speed sensor i believe on top of transmission melted and broke. Getting a tow, but wanna know if transmission is broke? What symptoms should I expect??

I guess that would be a question for the plug company. I know he’s used it on Jettas and Passats for a while. Not sure what material he uses.The Reinzosil sealant was designed to withstand that kind

This page was of great help when I removed my dash on a 1999 EVC. I used the same foam as suggested and so far all is working well. It was a big job though.

Thanks for the write up! It’s a to do on my car (it blew foam a year ago, it’s time). I’d be concerned that the 3D printed plugs would warp due to heat over time. PLA (most commonly used in 3D

I used HVAC aluminum tape- get a well known one- I did it many years ago and it’s still fine, even after my second heater coil replacement. Phil B 2003 EV WE 286 kmi

In the past I've used the Landing Pads - it's a great system where you can easily remove the bar/tower assembly leaving behind only a streamlined and barely noticeable pad.? Our newish-to-us 2001

As others have said, thank you hugely for posting this PDF.? We have a 2001 EV which needs it done and I've been putting it off - could not decide which would be worse, the angst of having someone