开云体育

you need to compile on the PI Zero W for Dire Wolf to work. -- 73, AB1PH Don Rolph

This was reported back in 2021 and I filed a RPI bug report: https://github.com/RPi-Distro/repo/issues/278 It seems they rejected the report but I never saw that notification. To be honest, I don't

FYI - For all concerned, I opened a bug report and the issue is being addressed. https://bugs.launchpad.net/bug s/1980899 ( https://bugs.launchpad.net/bugs/1980899 ) Look for direwolf 1.6 version

Some Amateur Radio satellites use AX.25. Try this: direwolf -B 9600 -r 48000 Note the upper case B. 73, John WB2OSZ

No, I just edited the ADEVICE in direwolf. ... and I just noticed the same thing you did about the SignaLink capture control.

Hello Fabrizio, Direwolf doesn't support many of the different "unique" modems that operate on various amateur satellites. Even if it had a compatible modem, most likely the data being sent by the

Sorry. My mistake :-) thank you very much

I think this is what was intended: “I compiled 3.24, and now it is working :-) Thanks for the tip about 3.22 being bad.” Sent: Saturday, July 02, 2022 10:00 AM To: [email protected] Subject: Re:

I had an issue a while back and it was because when GPSD was installed, it was a very old version. I built from source and all my troubles at that time disappeared. So first thing to do is check the

Which satellite? 73 de Prof. Chris Lance WW2BSA

Hello David, I'm preparing my station to receive a GMSK transmission for a satellite to be launched. I have a WAV recording that has been successfully decoded with HS_SoundModem. I would like to do

Hello Fabrizio, Yes, Direwolf supports GMSK but specifically receive-only AIS decoding: https://raw.githubusercontent.com/wb2osz/direwolf/master/doc/AIS-Reception.pdf What is your specific use case?

I compiled 2.24, and now it is working :-) Thanks for the tip about 2.22 being bad. John / LA7AKA

To install: - install the gpsd package for BullsEye - substitute the gpsd-2-23-2 image for the installed gpsd image You may get some warning messages with some apps. You will have to use the

I had issues with 3.22 where coordinates did not update. I found that 3.23-2 works approximately as expected. There is a deepp bug for one type of GPS unit, but it is relatively minor. I have an image

Hello All, can Direwolf decode GMSK modulated signals at 9600 baud ? Thanks in advance Fabrizio IU5GEZ

I am running 3.22-4. Do you know if this issue is in this version?

Hi Group, Same finding than Geoffrey F4FXL running 1.7E: message identifier missing/erased, no ack possible 73 de Cyril - DF1CHB - F1MHV

Replying to myself....? hi :D Fixed the issue ... https://github.com/wb2osz/direwolf/pull/407

It is even worse than expected. Even RF to RF message digipeating is broken. Direwolf inserts NUL char into digipeated messages. I opened two issues on github :