开云体育

Some Amateur Radio satellites use AX.25. Try this: direwolf -B 9600 -r 48000 Note the upper case B. 73, John WB2OSZ

No, I just edited the ADEVICE in direwolf. ... and I just noticed the same thing you did about the SignaLink capture control.

Hello Fabrizio, Direwolf doesn't support many of the different "unique" modems that operate on various amateur satellites. Even if it had a compatible modem, most likely the data being sent by the

Sorry. My mistake :-) thank you very much

I think this is what was intended: “I compiled 3.24, and now it is working :-) Thanks for the tip about 3.22 being bad.” Sent: Saturday, July 02, 2022 10:00 AM To: [email protected] Subject:

I had an issue a while back and it was because when GPSD was installed, it was a very old version. I built from source and all my troubles at that time disappeared. So first thing to do is check the

Which satellite? 73 de Prof. Chris Lance WW2BSA

Hello David, I'm preparing my station to receive a GMSK transmission for a satellite to be launched. I have a WAV recording that has been successfully decoded with HS_SoundModem. I would like to do

Hello Fabrizio, Yes, Direwolf supports GMSK but specifically receive-only AIS decoding: https://raw.githubusercontent.com/wb2osz/direwolf/master/doc/AIS-Reception.pdf What is your specific use

I compiled 2.24, and now it is working :-) Thanks for the tip about 2.22 being bad. John / LA7AKA

To install: - install the gpsd package for BullsEye - substitute the gpsd-2-23-2 image for the installed gpsd image You may get some warning messages with some apps. You will have to use the

I had issues with 3.22 where coordinates did not update. I found that 3.23-2 works approximately as expected. There is a deepp bug for one type of GPS unit, but it is relatively minor. I have an

Hello All, can Direwolf decode GMSK modulated signals at 9600 baud ? Thanks in advance Fabrizio IU5GEZ

I am running 3.22-4. Do you know if this issue is in this version?

Hi Group, Same finding than Geoffrey F4FXL running 1.7E: message identifier missing/erased, no ack possible 73 de Cyril - DF1CHB - F1MHV

Replying to myself....? hi :D Fixed the issue ... https://github.com/wb2osz/direwolf/pull/407

It is even worse than expected. Even RF to RF message digipeating is broken. Direwolf inserts NUL char into digipeated messages. I opened two issues on github

I made? a second test with my FT2. The received message is clearly missing the sequence number when dispalyed in the raw screen. I'll make an issue on GitHub. This is a *serious bug* as messages

What version of GPSD are you running? GPD 3.22 has exhibited this issue in the past. -- 73, AB1PH Don Rolph

Thank you for replying David! 1. I am running version 1.7 from Git 2. Gpsd service is running yes. And cgps and gpsmon shows correct position. I have not checked it while traveling though. I will do