I had an issue a while back and it was because when GPSD was installed, it was a very old version. I built from source and all my troubles at that time disappeared. So first thing to do is check the version ¡°gpsd ?-ver(?). if it is not current, bult it again.
?
IIRC, I had to edit my gpsd.conf to point to the GPS source. I don¡¯t recall the steps but I did find information on the gpsd site.
?
You can ping the gpsd group and I can almost guarantee you will need to be running the latest version.
?
When you think everything is correct, run cgps (?) from the command line.
My TBEACON and SMARTBEACON setup only fetches new GPS position at reboot. Beacons are sent, but the GPS position do not change throughout my travel. If I reboot the RPi, it changes.? ?I am running Direwolf on RPi2.
