On Thu, Oct 5, 2023 at 03:10 PM, John Lindo wrote:
My lathe has metric leadscrews and all RELS menus work OK, I mention this as I read? you were concerned this mix of Metric/Imperial was maybe the cause of your non operative problems.
I would like to clarify this point. What John says is completely accurate; you can mix metric and Imperial
threading pitches. But you CANNOT mix metric and Imperial
feed rates, As it states in the RELS_data_VX.XX.xls file, "Instruction" tab, row 24: "Only one Feed table is allowed in the TablesV4.h file!" The same is true for Version 5.
--
Regards,
Charlie
New Jersey, USA
JENNING’S COROLLARY TO THE LAW OF SELECTIVE GRAVITY:
The chance of the bread falling with the buttered side down
Is directly proportional to the cost of the carpet.
