For years I have used the Samsung Universal TV Module to control on and off, and volume up and down. This was used on my 48 inch Samsung and had no issues. I just replaced the display with a 60” Samsung SmartTV. On and off work great. Volume is causing some issues. If I hit up or down it jumps levels. IE If it is on 11 and I hit up it will jump to level 16.

Has anyone else experienced this issue? SHould I just run the IR learner on the new remote and see if that helps?
Joshua Bloom

On 20 Feb 2022, at 08:59, F David A Coker <david.coker@...> wrote:

?When you say audio routes, all of the devices are connected to the receiver via HDMI only.? Do I need to connect more than the AV inputs?

One more note, it wont even turn the unit on or off and it doesn't allow me to control volume either.

On 20 Feb 2022, at 08:17, F David A Coker <david.coker@...> wrote:

?I am installing a CH system in an existing residence.? It has two Yamaha Receivers (RX-V671 and RX-A1010).?

For the RX-A1010, I tried the RX-A1070 MultiZone and, although it shows connected, I have no control of the unit.
For the RX-V671, I tried the RX-V685 and, although it shows connected, I have no control of the unit.

Can someone give me a little guidance on what I am doing wrong.? Are there settings inside of the unit that I need to make to get it to talk or is there a different driver that I should use?? Please help.

Thank you so much in advance.

Hi Jay,
im using H&T sensor only as a temp probe but i have 2 questions:
1 - i see on console temp have one decimal, it is possible to have out module also?
2 - maybe my mistake somewhere, H&T push me info but i would have expected every celsius degree change but is not so. Now a'm thinking powering H&T every time i need temp feedback using power like polling, any advise?

many thaks in advanced
antonio