开云体育

The DMPS3-4K-350C-AirMedia that I took apart yesterday had a Panasonic coin cell battery in it. It also had an extra machine screw in it which was loose and rattling around, hence the reason why I

My latest article, "Bond Adds the Sidekick Keypad to their lineup of Smart Home Bridges” is being published by the good folks at Residential Tech Today Magazine on their web site. The new Bond

Yeah, I think I understand what you're saying. I just think that it still should remain a fixed value - Max is Max, what ever is the setting... perhaps they should have a separate value that

It is not reduced. As you keep increasing volume, MVMAX also increases and it eventually reaches whatever limit is set in the settings. Basically MVMAX doesn't show you true MAX but dynamic based on

Looking for a programmer name Michel. They programed IPIC theater in Minzer FL. It was a D3 lighting program.

Isn't the whole issue based on if the Max volume is reduced, you want to have adjustment on the volume FB??

I just confirmed that the PSDYNEQ is ON, at the site where I first found the issue...:(? ? ? ? ? ? ? ? ? ? ? PSDYNVOL is OFF. Thanks, Zac for figuring this out...This explains why this

My workaround will be to keep DEQ on, and treat MVMAX as constant (there is a calculation inside the S+ module based on MVMAX). Others may chose otherwise.

Hi All I have a request for integration with a DMP XR150. The history with DMP is horrible, so just seeing if for some reason, they have started to play nice. I'm assuming not but wanted to check

In other series 3 processor that I have encounter with bad SD cards, the symptom have been very long boot times or failure to boot completely.? In another case, the program occasionally gets erased

What are the symptoms? Just to compare notes. -David

I haven’t taken apart a RMC3 (that I remember… typing that I may have stuck the PCB for one in an oven once but my memory on that adventure is not crystal clear) but every other processor I’ve

Well if its that then you should be able to work around it or even turn it off if it gets turned on. I see theres commands for it in the protocol: Dynamic EQ = ON Dynamic EQ = OFF Request Dynamic EQ

It is the Dynamic EQ (PSDYNEQ ?/ON/OFF) - if ON, the MVMAX dynamically adjust with volume level - the higher the volume, the higher the MVMAX goes, up to the set limit. With Dynamic EQ off - MVMAX is

I cannot speak for all Crestron products, but at least my CP3 has a CR2320 3V Lithium coin battery in it.? As a side note, I don't every recall a Crestron processor losing time completely it doesn't

Do RMC3s, CP3s, etc. and 4-series have a battery for keeping internal clock?

That's interesting! I hadn't thought of that...

3 series but this has nothing to do with the processor. I am monitoring the AVR with putty. The good news is it is at home, so I should be able to figure out what's going on. It may be related do

Folks? - I have a DMPS3-300-C that is way out of warranty and it has gone sideways. I suspect the SD Card Image is bad. How would one go about getting the image? Best regards AV Programmer End of

Yes, this kind of behavior was what I experienced and was the catalyst for the thread a couple months ago!! Are you using a 4-series processor? In my case the project started with a 3-series (waiting