开云体育

As I recall you may have to use different modules depending on the firmware of the vista panel

Aloha, We had the same problem, replacing the PoE switch fixed the problem.

Heath is absolutely right. Please report these even if its from the online help form. I have a job with 60+ TSW-750s and so far with ~24 installed all is good but I'm really not doing much with them.

I'm with Phil on this one. I haven't used an interlock symbol in years...

This has to be done by the bacnet programmer for daikin. There is a software key that they must have to enable this in the daikin. From: avprogram <avprogram@...<mailto:avprogram@...>>

Ah, that sounds like a feedback loop. With the uncertain amount of delay induced by an EISC, you can easily get logic that seems sensible and works locally, but creates a do-it-yourself oscillator

This is the Crestron official module, Its done in SIMPL, All i get to do is Send commands as far as Arm and Disarm the System and able to get a (FROM DEVICE$) signal in debugger for any sensor that

"I" wouldn't suggest anything ;-). It does seem sensible though. As long as your network is up to speed, and the cabling is good why be bothered with these stupid things? The guy I talked to at

Does anyone know how to Enable the Bacnet Ip in a Daikin system. Need bacnet IP Enabled and was told must support Whois lookup.

Does anyone know how to Enable the Bacnet Ip in a Daikin system. Need bacnet IP Enabled and was told must support Whois lookup.

Does anyone know how to Enable the Bacnet Ip in a Daikin system. Need bacnet IP Enabled and was told must support Whois lookup.

Are you using the Crestron module? This being done in SIMPL? Do you have other features working, just not getting the text strings? Do you get any other feedback? When I was messing around with this

Thanks Heath, quick question, would you suggest that I turn off all of my Autonegotiate settings for all of my crestron equipment? I currently have them on a Cisco gig switch. I ask this because I am

Make sure you guys are reporting these little, "just reboot it" problems. They aren't so little when an entire project with multiple panels gets into this condition. Crestron knows about it, at least

It would, until you need feedback from the device. In addition, INIT/EQUs are *much* more flexible than ILs - especially when you have multiple things that can trigger the value.

Well as a wise man once said.. "to each his own..." I find it easier to use an interlock and I was just sharing the way I do it. If you have a suggestion for him, maybe let him know.. EQU would

I have a couple that were going off line and we suspect that it may be due to a network switch trying to "renegotiate" connection speeds and the EXGW just gives up... HP switches being a big culprit.

Funny thing is that this is the second one to do this. I origionally thought it was a power problem and therefore purchased a 75w power supply just for it but, unfortunately, it is still having the

Why use an IL and an INIT? Why not feed the INIT with the button press, and EQU the DMPS output FB for your button feedback?

I have installed a couple of these now and both of them have a habit of going offline. They are still available to toolbox but the processor looses connection with them. First, has anyone else seen