开云体育

Depends on the unit - all the matrices I've seen in the past few years have provided a message any time someone makes a change from the front panel. The module I use for parsing - the same one that

It's been awhile since I put in an Extron Switcher, but I believe you are going to have to Poll the unit to set its feedback changes.

Those look pretty good. Where can they be purchased? raphaelthiffault@...> wrote:

Hi all, just looking for some quick advice, i have an extron 8 n 4 out matrix switch which all gets powered down every evening, what im trying to do is get fb from the switch to the tp, so say i

I know a 35 watts ceiling amplifier who works great with rs232 control.

Has anyone used any new HDMI cables with Redmere technology with DM setups? As far as I can tell, they are not compatible. When a 6' Redmere based HDMI cable is connected to a DM-RMC-100-C and feeding

I have a few of those remotes that I'm also responsible for. I ended up using a Virtual XP release from Microsoft: https://www.microsoft.com/windows/virtual-pc/ I have also run Windows XP loaded in a

I believe it was a direct quote from one of the Crestron engineers on Labs. JRW

Can you re-post the posts that were removed, so that I can see and understand why it had to be deleted so that it does not happen again. FYI, I am not serious.

Thanks Marty. It's a strange one, it boots halfway, looks like it is going to work, and craps out around the time it should be showing the Crestron logo, maybe 10 seconds into the boot.

Not running 64 bit but running Win7 Prof and last month was able to connect with little issues. Remember that you have to check the box in Toolbox when installing to have the drivers installed.

getting ready to do one. I guess I am very lucky on this one because I am using an MPC-m10. YES!!!! "I am sorry you must use the polycom remote" LOL....

The NDA police are ON it today ;)

Hi J, Thanks for the suggestions. No, I don't believe the device tree is that deep? Computer -> DM-TX-201-C -> DM 8x8 (DMC-C-DSP) -> DVPHD -> DM 8x8 -> DM-RMC-SCALER-C -> Sharp TV. In DM Tools it

Is there some trick for using the Core 3UI RSS feed smart object? I have it loaded in my project, my AV2 has DNS addresses, but I get nothing. I am currently using the default rss feed:

Dtools then quicklinked into quickbooks. Been great for years. We still have job/service check out sheets that we turn into service tickets to track techs in qb. Trey please excuse typos, courtesy of

Lol! Very true!! - Chip

Hi, Yes, I've tried that, it does work fine by routing a DMCO-55 hdmi output to the DVPHD, but I end up wasting a DM output which i will need... Wish there was another solution as I'd rather not have

Gary, sorry, but I'm not familiar with the dxp dvi pro... If it does routing the same was as other Extrons, I would imagine that the protocol would be the same, and the module would work just as well.

Or to exchange it for a unit that already has 16 gig? - Chip