开云体育

Has anyone ever used something like divmod in SIMPL+. I need to work with decimals. Any Ideas?

Turned out to be a bad (new) USB cable.

Yes, I made sure that i disconnect from EC in Module 1 and it still doesn't work. Neil, I get what you are saying but I thought multiple ECConnect's in a single program is allowed? -- Sebastian

Lincoln, Did you add the relevant entries in the PRO3's Ethernet Control Subnet setup page? (I just did the analgous thing for an AV3.) ---John Krommes

Bryston is not actively working on creating a module for the masses. One of the people I spoke to loosely mentioned that if one of the dealers wants to take on that responsibility, they may be

+1000 I'm 3000kms from a large enterprise commercial project as we speak and remotely updating firmware and VTP projects on 90+ TSW-750s. Flawless and painless...

You're also using multiple ECCONNECT symbols in this example. If these crosspoints are all related to each other, you likely want to use a single ECCONNECT to maintain a mutually exclusive connection

First, are you using Crestron software development tools? If so, are you connecting those tools to Crestron hardware? If the answer is yes to both of those questions, then what you are describing is

Thanks. I used an ASUM, SMV, and RMV for the signal delay, took the original analog into a SAMPLE, and then used the ACOMP2 to determine if the motor was moving up or down. Seems like an awful lot of

While I completely acknowledge the growing pains and evolution of the new products, one thing I think some folks are missing are the new tools for deploying firmware and graphics updates such as FTP

Are you disconnecting one EC before connecting the next? Chris [Non-text portions of thi

Am I delusional or crazy? Wait. Don't answer that. I was under the impression that the processors with Control Subnets (Control Subneti?) were supposed to automagically configure port forwarding to

Dmps Rm 100c room box or rm-scaler Dvphd Nick Sent from my eMail.

Hey All, I built a module that has a CCross, ECross and ECConnect to control various equipment. The problem is that, when I have more then one instance of the module in the program and try to

I've never had an issue with rebooting the panels - except for the graphical instability when first touching objects. It's when they aren't rebooting that the problems show up.

I think Heath has hit the solution in the PERIDOCREBOOT_ON command for the TSW series. I am going to confirm that it has been enabled on a job tomorrow. The solution sounds logical, however I'm still

Delay the position value by a few waves by wrapping it through an ABUF, then use ACOMP2 to see whether the new value is higher or lower. Depending on how fast it's moving, the > and < outputs won't

Sample the existing value with an ABUF and use an ACOMP2 to determine if the next value is greater, less or equal to the sampled value. [Non-text portions of this message have been removed]

I have been given the OK to put together a list of equipment that I would like to have as a sandbox to play around with. We are just starting to switch some of our classrooms to Digital. My question

Is there a way to take an unsigned analog and determine if the value is ramping up to 65535d or down to 0d in Simpl? Obviously, you can use a slider but I've been forbidden the use of these in this