开云体育

SETL 0 That's the command Lincoln was referring to. Sets the auto-log-off time of a processor, in minutes. Zero turns the function off. -- Josh Winn The LiquidPixel Group

yes. the serial I/o product works great. ?I have used them to control AppleTVs and Mac's. ?They just appear as a wireless keyboard- easy peasy. Get the BlueSnap DB9 w/ FAST-HID firmware option and

I threw the code and the instructions into a Pastebin --- https://pastebin.com/c2MPHAZ0 -- come back and search for this later if you decide to try it. My Pastebin contains links to order the same

Hi Michael, that sounds really cool, although I might have to agree that my mileage would/will vary as I have not worked with Arduino before and don't use ChatGPT... ;-) I was hoping for a

CPU2 or CPU3 card? If a CPU3 card you may be up against the idle timeout auto logout that all 3- and 4- series processors have by default. There is a command that you can used to adjust the time or

Ok, so RS232 to Bluetooth HID keyboard? Here we go! Just for fun, I went and grabbed an ESP32 Arduino microcontroller (actually I grabbed an M5Core Basic, which is an ESP32 in an enclosure... because

Could someone direct me to a currently available and working *RS-232 to Bluetooth-HID-Keyboard* hardware adapter that could be used to control a device that accepts Bluetooth keyboard commands? Had a

As per title, I'm trying to work on a remote site through TeamViewer. Each time I step away and come back, the Tool has disconnected.

Hi Folks, Is there anyone have a working module for crestron and modbus RTU integrations., other than crestron application market which is not working for me to communicate with a VMS(vessel

This worked for me admin Crestron123

Is PAGEJOINTRANSMIT a command-line feature of the DGE-200? [email protected]> wrote:

Thanks much, metalmok; I got it working.

Hi Chris, OK, now i understand the setup. Well, I guess that?s the reason why we prefer to connect everything directly. Any chance to at least connect the sources directly to the Trinnov and then

When the touchpanel page has a join, and the interface is showing that page, the corresponding press join will go high.? This is normal behavior.? You can track what page you are on in SIMPL if you

i had to rebuild a prodigy system from scratch the composer locks 3 buttons on the keypads, top is on/off, bottom 2 are vol +/- problem is that the vol+ button doesn't have any code in the OLD days

Dear Udhayan, sorry - the 300Z has no Ethernet port either. It can only be controlled by the factory supplied IR remote or front panel buttons.

Dear Bauer, Sorry, i am looking the command strings to control DN-300Z over IP Control Regards, V.Sudhakar udhayan <igor.pero.bauer@...> wrote:

I have not run into this on this panel, but have many times on the 6L, this is a "feature" that was necessary for systembuilder if I recall correctly. I'm pretty sure it can be turned off through text

You might also look at Shelly’s line of PM devices. They can do power monitoring of both AC and DC loads. There is a Crestron-Shelly driver on my GitHub Hope this helps Jay

I think Brendon is indicating that there is a press held high in the program, not that the button is in an 'Active' state, though that may be also the case. The only times I've seen this is in the old