开云体育

I find when this happens that the owner breezed through, and didn't allow for the "Local Lan Connection". And it now needs to be allowed through the iPad settings/Crestron_Go App.

like the others mentioned, you are just creating a 'Serial String' matrix switch. Matrix Inputs are from each of the NVX Encoder Stream_Location_F as the 'Sources' Matrix outputs are sent to the

I'm curious what brand Emitter you had and what you replaced it with? FTR, I have for years said to only use Xantech emitters, and that it has been the fix for similar issues when I had happened to

It sounds like there is not proper network management to stop the Multicast traffic from entering the main network when you connect the NVX switch to the main (Control) network. The port on the NVX

As others have suggested, the StreamLocation and StreamLocation_F signals are the easiest way to do routing. I have a module that uses analogs like you would with a traditional DM frame and routes

Thanks for writing this up Nico.? Great information. I will take a look at my module and see if there are things I can do to minimize the calls to the Sensibo Cloud. I will let you know. Thanks

Chuck, You can't do that, but you could run all your Stream_Location_F signals into abufs and an MSP. The output of all the abufs would be the same and you could use your choice of logic to enable

create a new Simple+ module with something like the following. Then connect all the location feedback (from decoders for FB) "Dec_Stream_FB$" (From encoders for locations) Enc_Stream_FB$? then

No can do, Chuck. SIO parameters are set at compile time. You can't dynamically change the SIO parameters while running a program. Marty

Hi Joshua; I don't know what port/protocol the module uses, but Panasonic have enforced security measures disabling the LAN control by default on most if not all newer models. I suggest you check the

Can I take the serial Stream_Location_F from an encoder and have it populate the parameter field on an SIO directly? or do I have to create a module and use an argument to fill in the

Hi Jay/Thorsten using sensibo too since 1 month.. I have a CH system and at first, I've tried with the cpllc driver.. with only 1 sensibo at the system, it worked perfectly with no issues.. control

Thanks for the quick reply. Good news then!

Yes, it will work.. just choose it as “sonos amp” when Crestron home asks to Regards nf Sent: viernes, 2 de agosto de 2024 09:57 a. m. To: [email protected] Subject: [crestron] SONOS

Sorry if this has been posted before - I looked through the forum and didn't find anything. I have been using Panasonic PT-FW430 TCP-IP modules from the application market with no problem, I'm

Sorry, should have been more clear... When it comes to using NVX, i cant find anything that shows me where lines should be connected in simpl.

I am also looking for information.? It doesn't appear as if there is much out there.

Hello. We have a standalone audio zone consisting of several 70V in-ceiling speakers being driven by a "dumb" 70V amp by QSC. Client wants to add this audio zone to his Crestron Home system, but he

Did some additional troubleshooting and resolved issue yesterday. Replaced IR Emitter and offset Emitter to IR receiver. Numbers don't seem to duplicate any longer. Tested about 15 presets and zero

We use streamLocation strings for routing, instead of subscriptions, since it's less time configuring devices. But it's a little more programming if you want to drive routing with analog values. So if