开云体育

Hello everyone, last week I had set up a VC4 on my linux virtual machine, following the instructions I did hardening of my machine to be able to debbug my test softwares. After hardenning and adding

Hello All A Newbie question but I did some searches and didn't find anything immediately. IR Controlled Device 5 Inputs No Discreet Codes I understand that there is potential for this to get out of

Thank you, ill check this when I get back onsite

Thanks for the quick reply - I did not think I needed to control the visibility of the Smart Graphics Embedded Video App, but that is all it was - thanks again.

if i connect in the front USB asks for password. if i connect in the rear USB, it doesn't ask, and i have console. But the rear is for the A/V only as i read, not for the processor. Correct me if i'm

What firmware is on the cp3? I do know some of the earlier firmware had self signed certs that would expire. Also verify the clock on the CP3. SSL requires the clock to be within a few minutes.

yes, the combination is Hw once Sw for 20 sec, but? i will loose and the "out of the box" experience i think. (correct me if i'm wrong, other DMPS-300-C that is not locked, when i connect with

Anybody have a solution to the Trust Failed when trying to connect a iPad to a CP3, i have a project with 2 PRO4's and 3 CP3's, i have ssl turned on and each processor has its own ipad page, when i

Aqara designs and develops hardware and software solutions for the smart home.They have over 12 million customers in more than 170 countries and territories.My latest article, " Aqara Introduces the

Hi Tony, There is an URL parameter that I've recently added support for on the PushOver module.? I can't remember if I've uploaded that version to my GitHub yet, or not.? Unfortunately, that

Jay, could a URL scheme be included in the Pushover notification, to allow opening another app (such as Crestron Go)? I've done it with text messages before, but haven't tried it lately.

The IP table entry for inter-slot communication is 127.0.0.2 in all programs that need to talk to each other.

I don't have the time right now to get into all the details of your design but the first thing you need to do is to change the IP addresses on your inter-slot EISC symbols to 127.0.0.2 That is the

If you connect with a USB cable it will bypass the password prompt and then you can reset it in the network settings.

Hi Dave, Glad you like it.? You may want to try the PushOver module I wrote instead of Prowl.? There are a couple of advantages and one disadvantage.? First, PushOver supports both Apple and

I really haven't done much with multis-lot, but have a project that requires a more modular approach. Processor is an RMC-4 (with multi-slot license).? I seem to have a lot of issues with programs

Hey Jay, Actually it was my bad.? As I indicated below, I had forgotten to set up the DNS servers on the new processor.? Your module is still the Bomb!! Thanks, DAVE

You Da Man!!? That's exactly what the problem was.? When I move the program over to the new processor, I forgot to set up the DNS servers on the new processor.? I just put them in and all is

If it is the prowl module that I wrote, it is trying to resolve https://api.prowlapp.com.? I don't seem to have a problem resolving that. Jay

Hi David, Okay, the root cause from this call stack is "Couldn't resolve host name"... that's a DNS lookup failure at the beginning of an http request...so either a transient network outage or (less