开云体育

Need to Control some PTZ cameras.? Do you have module will pay for it.

Those codes worked great thank you sir

Hello. I use WOL to turn on LG TVs after they get offline. I have been using it on 3series, 4series and VC4-PC3 without problem.

Hi, I have this working fine on the VC-4. If you haven't followed these steps, i think it will solve the issue: https://docs.crestron.com/en-us/8913/Content/Topics/Harden-VC-4.htm Regards Flemming

Does anyone have an example of Home-Connect-DL door lock? I can't seem to find any info on it. Thanks

Hi, UDP ports < 1024 blocked on VC4. It seems not possible to open these on VC4

I don't feel they did a great job of actually documenting this. For #2 you are correct, the client needs to create an account then add you as a "Support Provider" under the Settings -> Support

Yes, I would like to know as well!

I have take all the XiO Cloud courses but have never gone through a formal deployment. I am not clear on the best practice of deploying via XiO Cloud in the following two conditions. 1. *Client does

Sweet , Thank you Jonathan

I know this is an old thread. I found it when googling for the same issue. YES, you can issue a console command to stop the debugger data stream DBGSIGNAL RESET ALL

I to am dipping my toes into Construct this week. I was sent a test TST-1080 for evaluation and wanted to build out something in Construct before I felt comfortable deploying projects in the wild. I

0% is \x08\x22\x01\x00\x00\x00\xD5 and 35% is \x08\x22\x01\x00\x00\x23\xB2.

Currently i am using Wake on Lan to turn on a Remote PC via VC-4. My code is working fine on Cp4 but now when i transfer the code to VC4 it doesn't turn On the PC. Is there any help I can have from

How you make the first initialization works? For me I need always to use C-Bus Diagnostic Utility, connect the?c-bus PC5500 and control it there, Once I can control it, I remove the cable connected

If it’s like the TSW-730/732 it shows up on a device extender (but I’m not opening SIMPL right now to say which one ;) ) – note that the switch short is from 24 to the input, not the input to

The webpage indicates that it has 2 Occ. sensor inputs. looking in SMW I don't see any triggers into the program (maybe I missed it??) It may be something dedicated to some built-in app function... I

Need a Network guy that knows Cisco , ?asap in Houston area.

OK will give that a shot thanks, Really only need direct set for volume all the way down @0 and another one for like 35 percent

EX-Link,Lincoln