开云体育

Slip, I bet the SystemInfo issue you are having is related to the hardening of the processor. ?This command "SETLOGOFFIDLETIME" defaults to 20 minutes IIRC but can be changed. ?If you have text

I have a Tivi DVr and 4 TiVo minis, I am using the TiVo 3 series module and can connect to the main DvR unit via the Ip and control the unit. The same module will not connect to the ip addresses of

Yes, "check for update" is enabled in the ipad IOS settings for all the panels. And the panels are being updated. The ones in question just don't see the logic ie the new ir file. They see graphic

In the main iPad iOS settings if you scroll down to Crestron Mobile Pro G is "Check For Update" enabled? If not then it wont pull the new UI update it will keep using the old one.

It's not available. Already been through this with Lutron. You have to use the modules provided by Control Concepts. So

Hi. Is it possible to control the sensitivity of the knob in an MPC3-302? OOTB it's giving me a resolution of 5,461d, meaning it takes only 12 steps to go from 0d to 65,535d, which is unacceptable if

Hi All, Anyone has access to the new Lutron LEAP API? I do not have a Lutron account.

Always slot 1 for me in multi-slot systems. The system info tool takes forever to populate, quite often hanging at 30 or 50%. EDIT: Also, another thing that is different to 3-series - If I open system

Sometimes it is easier to troubleshoot with multiple user interfaces if you use unique signal names on the touch panel and ipad definitions, such as TP01 Projector Power, TP02 Projector Power, iPad01

The buttons are joined directly to the ir driver for the new projector. None of the ipad symbols in simpl use any buffers. The ir commands now work in the new panels. There was an issue with the user

Which is really stupid as they really should be setting these for User Project once they leave the factory. Especially since they have a dedicated -R version of these just for CH. Which is also

I'm having the issue with the latest release at a site I was at last week.? I have 3 slots in use and the issue only seems to happen with Slot-01 for me.? I don't know if t hat is because it is the

Are the buttons directly joined to the IR driver or is there some logic like buffers or xpoints in there somewhere?

I've had an issue like this and chased it for too long. Turned out to be a duplicate IP address. Dante and control had the same IP. Dante audio was passing just fine but the switch was very confused.

Thing is, the project file IS being updated in the ipads with the issues. New buttons and changes show up no problem. If I include logic with ir codes that already exist in the program there is no

I've seen a couple of cases where I had to uninstall the mobile G app from the iPad and reinstall it before it would update the project file.? Seems to be dependent on the model number of the iPad

Check Device ID.. should match with device ID in program if set The content of this email is intended for the person or entity to which it is addressed only. This email may contain confidential

Sony has two different protocols.? One is called CIS-IP1, used for the Sony STR-ZA3000ES module, connects on 33335.? This command set is also used for RS-232.? It is also used for the STR-DA5600ES

Not a silly question at all. Yes they all have the same name.

Hey Fabio, I’m using several slots. AV program is slot 1, climate in 2, Lights in 3, Pool in 4, Sec in 5, cameras in 6, power outlet resets in 7, Touchpanel program #1 in slot 9, and TP program #2