开云体育

Am in web page to see if ADCP is turned on. Of course, it prompts for a password. Cannot find the default PW anywhere. Anyone here know how to do this. Already did a factory reset so it should be the

Trying to control this projector from a Crestron HD-RX system. Wiring and baud rate seem good because when I send this: power \x22on\x22\x0D\x0A I get this in reply: err_cmd\x0D\x0A Any ideas? Do not

Thanks for the comments and information in this thread. Without getting into NDA territory, is this a REST API device, simple TELNET, SSH? JSON required? CLI? POST-GET formatting? Having access to the

Hi, if you don?t want to just to cut off content, then you need a videoprocessor capable of scaling every content into your 2.35:1 AR. The one videoprocessors capable of doing so is the Lumagen you

How do you have your SIMPL TSW hardware definition IP Net address settings configured? If you don't have a "Default Address" defined (goes for any IP device) in the HW definition settings an IP table

When it comes to IP Table entries, most Ethernet devices are written to the .dip file (found inside the .lpz). However, some newer devices (CEN-GWEXER, CEN-IO-XXXX, etc.) use a different mechanism to

Zoom would 'throw away' a third of the content, which may/may not be preferable. I would contact AV Pro Edge. They *May* have a box that does it... FTR, I don't think that DM or NVX have this feature

Agreed with JohnMax.? It's the old adage "Just 'cause you can...doesn't mean you should!"...:) Also, you want to/have to manage the *RF-IDs* so that you don't have duplicate device IDs...It's obvious

A simple solution would be to simply have the projector zoom and use its masking feature to crop out any over-spill. With the quality of today's projector crop, this throws a pretty good image even by

It should only be done as Ckangis stated. You cannot use the same IP ID on two program slots of a processor. If you were sharing the gateway between two processors though, you could use the same ID in

Thank you so much! That was the problem.

The biggest problem with Evertz is how unhelpful they are if you have any questions.... Had one of their MMA-10G products and I was trying to wrap my head around theory of operations, capabilities,

Hey everyone, ?I inherited a decent sized retail job and the previous contractor installed a fairly large fixed 2.35:1 ish screen on the wall. ?The projector is a fairly new JVC 8k of some sort.

Did you verify that Lock Configuration wasn't turned on?

I have only noticed this on a few projects. No rhyme or reason to it.

Sometimes when a program is recompiled the IP table entries are in a different order. This will cause the warning. I have discussed this with TB but only in passing. I first noticed it with an NVX

I can answer general questions but I can't send code samples because the protocol is released to my company under NDA. That said, the coding was not difficult at all once the hardware is setup

I'm looking at some drawings for a system that uses this Evertz product and I need to price out time for it. Does anyone have some code examples that they are willing to share? I'm currently trying to

i found; " Hold SETUP button for 5 seconds to enable/disable" but... anyone know the textconsole command?

I think that there might be an issue with ProG deprecation and newer iOS software...I can't remember the details but others probably will weigh in...