开云体育

Are you working with a 4KZ switcher or a 4k? On the 4kz, the top has been shutdown by the engineers because of security flaws. The "conf output 1 route 1" command works on the 4k but not 4kz. Extron

Wait so you have the protocol to control that switcher without needing a Crestron controller? Would you mind sharing? Cheers Natalie

if you have the unit, test with with Putty from you laptop. the unit i have works on TCP port 23.

Hi Juan, that is strange. I found a driver in the Crestron application market (for the whole TD-E series), dated back to 2016. This driver as well states that the communication settings have to be set

I wish I had a Crestron processor. I'm using extron processor. :(

You add the device to the system configuration in SIMPL windows. Set the ip address for the device in the device settings. Then you load the program to your processor. The device will not register in

Will it work with UDP? The engineers at Crestron locked tcp port in the 4kz series of switchers.? ?That's what Crestron is telling me.

I don?t see any of that in the menu of LCD Toshiba

So for the CBD keypads that have the 'Lutron button 6 tax' applied, even though the image will force/show the split button 6 only, you can still program button 6 as normal and your 6-btn/non-split

That is interesting. You can try using Extron EDID Manager to create an EDID file or modify an existing one. There are lots of options, either get someone that is familiar with EDID or use the try and

Hi Juan, did you enable RS232 in the Menu, Setup, Control and set the proper baudrate? Afaik, the Toshiba uses Pin 5 for GND, Pin 3 to receive the commands. Best regards Crestronfreak55

Yes, but not work

Those are, I suspect, Hex values, not ASCII values. Have you tried, for instance, \xBE\xEF\x03\x06\x00\x19\xD3\x02\x00\x00\x60\x02\x00 in an SIO?

Hi CrestronFreak. The Samsung has the ability to rotate the image and stretch if required so sending it a res of 1080*1920 does work, ie, a signal from my laptop running that resolution, but I just

Hi Bambam_101, using a display in portrait mode is not a matter of EDID. The video signal is still 1920x1080 and the display shows this as received. The orientation cannot be configured in the EDID.

Hi Im try to send rs232 commands type ON BE EF 03 06 00 19 D3 02 00 00 60 02 00 OFF BE EF 03 06 00 19 D3 02 00 00 60 01 00 GET BE EF 03 06 00 19 D8 03 00 00 60 07 00 Also by CEC, now i want to copy

Hi all. Currently doing my first Barco We Connect system and we have a Barco node (Intel nuc) that is connected to a Samsung lcd screen in portrait mode.? Problem is, there is no way to set the

there is a previous thread on thsi need add "conf" in front ex: conf output 1 route 1

you can TCP to the unit on port 23. I am using a hd-md4x1-4k-e. The syntax will be input <n> syncdetect <true/false> frontpanel lock <true/false> output <n> route input <n> name output <n> name input

Just trying to put back the original program like it was before.? Old Cameo for Old Cameo and New Cameo for New Cameo.? ?All 6Btns & 3Btns.? I looked on some old hard drives from jobs back in 2009