开云体育

The outputs of the analog step could be connected to an EQU to and SIO to send the discrete steps. As an analog you can store it like any other signal. As you stated, you could just use a raise/lower

I send the discrete volume level to the AVR.? It is much easier to deal with it that way.? Use a volume control module to generate analog value then use a bit of logic to send it.? Plus is it is

Have you tried using an Analog Increment set to the actual 97 steps that you are using? The delayed feedback would force it back in a native format so that you aren't dealing with rounding issues. You

?Re: dB display - our normal clients barely understand %, dB would confuse them even more!! HaHa!!“ Ouch! ? Von: [email protected] <[email protected]> Im Auftrag von ckangis Gesendet:

Re: dB display - our normal clients barely understand %, dB would confuse them even more!!? HaHa!! Re: adding the two extreme values: I'll look at that, but I think that the basic issue is analog

My latest article, "NFC Tags – An Inexpensive Smart Home Automation Application” is being published by the good folks at Residential Tech Today Magazine on their web site. If you are interested

I tried various different modules from the sx80 v1.4 to Cisco room devices 4.0.? At the end?of the day I used a combination of the SX80 v2.3.9 and some serial I/Os for certain xcommand functions we

I tried various different modules from the sx80 v1.4 to Cisco room devices 4.0. At the end of the day I used a combination of the SX80 v2.3.9 and some serial I/Os for certain xcommand functions we

Hello , I updated my PC with the latest Crestron software . After this I can't open any *.smw file at Simpl Windows The Simpl Windows program is booting and *Shuts down suddenly* before? ?the

Good morning, I wanted to ask if anyone has worked with Cisco Room Kit Plus with Room Os 10 firmware. Do you know if there is a valid module for this version of Cisco software? Do you know if Meet can

Hey, just a thought. you say -80.5 reads mute and +16.5 max on the panel display but coded should still give you the additional 2 steps to get you 99 increments. Would this not allow it to operate

Hi, doesn?t answer your specific question, but we always prefer to present dB values to the client rather than just % values. So i wouldn?t do the conversion and just present the dB value as it

Make sure you have the EDID dongles in place that come with the flex kits. I had this happen recently and the install guys hadn’t put them in as per the “do” guide Tim Greenbank Control Systems

Just wondering if anyone has started coming across this?? Have been to multiple sites today with recent Flex installs with reports of the output to the display turning itself off and requiring a

It is been a long time since I used the ootbf feature in the adagio -- probably over 15 years ago.? All the systems we did that started off doing ootbf where converted to SIMPL as the ootbf had too

Hi All, I've been struggling (read 'above my pay grade'...Ha) to get volume control of an AVR (Yamaha AVR) working correctly? - more specifically getting the volume feedback to behave... Here's the

Thanks >

I use lutron qs shades with Crestnet cabling. Works perfectly.

Lutron QS shades would work great too. Could use the existing cabling. Ryan Cunningham

I have only Cresnet cable at each shade.? It appears the Draper IntelliFlex is 120v, also requiring a separate data cable?