开云体育

It's meant to report circadian color temperature, not light intensity. You can even get intensity off of a GLS-ODT-C-CN if you have any on the project. Otherwise, the lux value may provide some

I am trying to replace a ceiling mounted BEG automation PD11-KNX-FLAT bus occupancy sensor with something compatible with Crestron. ?Problem is it fits into a roughly 2" diameter hole in a concrete

Ive been using that IOEX for garage doors and it depends upon whether youre doing it with PYNG or with Simpl.? When you first start the system PYNG is confused with the signal it receives as to

Hi Jay, Those are good points I hadn't considered!! - thanks! If you're talking about the device in the document I had posted, I should expect that it would do what you mention. It is a liftmaster

I'll give thay a try, may be the easiest approach. Thanks

Application Market Place.

I used the one pulled off the ptz optics website. Did your module come from crestron ?

Anyone work with this device yet? It reports more than an GLS- LOL, which analog value would you use to it reports like an GLS -LOL?

What module are you using? The Sony EVI-D100 worked out of the gate for me.

Yes, I said "maybe".?? Usually when something doesn't work in Linux, it is a permission problem.? In Thorsten error log, it had an "access denied" message indicating it was a permission problem.?

Don’t know specifically but is there a stop command that must be sent on button release? From: <[email protected]> on behalf of Dillon Costanza <dmcostanza1992@...> Reply-To:

Okay, I'll look into that thank you [email protected]> wrote:

Typically you have to send a stop command upon button release. IIRC I found a way to do it with a logic wave pulse I’m the Cisco SX-80 module. Hope this helps.

Thinking about this a little more I have a question. If you use the LiftMaster dry contact device is the LiftMaster opener smart enough to flash its lights and make a beeping sound (the way it does if

Thanks in advance

Hello set a few of these up and ran into some issues.? For starters the module off their website did not function properly.? Tons of errors and the commands were not written properly. There was an

I took a look at the uploaded pdf this morning and it looks like a really good solution. I didn't find this device during my research for the article I wrote and I don't believe that a lot of other

Although, as I just realized, Steve Kuehn was just hypothesizing about the cause, so this may be completely the wrong track... wrote:

The issue is with listening on ports < 1024 (ie TCP servers). Way back in the annals of Unix, someone decided that only root should be allowed to run services on ports < 1024 - this is what passed for

hi, i'm trying to send wake on lan command from the crestron. the computer is in a different subnet, but we managed to connect the networks, so there is a ping between the controller and the computer.