开云体育

In VT Pro, use the arrow next to the play button and "Run As" The settings you do there are saved as part of the vtz and will be used when you next run it

Hello, has anyone worked with a Delta 7th Sense Media Server? if so how do i get it to turn on using WOL? it seems to go to sleep after shutdown

That's not a bug - it's a feature.

/setup page stops working

Cough Core 110f cough.

Yes that trick works Phil, it's just an arse having to do it especially when you are on site and there's half a dozen contractors all bending your ear and you miss the opportunity. Thing is this used

Not enough room for all the connections on the back? Even for just a 7.1 channel processor, by the time you add the analog outputs and a small number of HDMI inputs / outputs, you would quickly run

I concur. I have discovered that if you go into the settings before it fully loads the file, it will have the last used settings (Address, port, and IPID) rather than resetting them.

I agree with Slip!! remembering the last setting should be default (I think it was that long before, wasn't it?) Dave H - This is one of many items that when I see it, it confirms my lack of

Has anyone seen any issues with this FW from last week?? Obviously it's supposed to fix the Sonos S1 Comm's/#Favs issue, but wanted to see if there were any unexpected problems... I have a couple

Not fully tested I see. Yes it kinda works if you run it from VTP with F11. Does not work if you double click the vtz. Still defaults to?42872. In my mind the default behaviour should be to default

A bit of off topic but why doesn't anymone make a pre/pro in 2U may be even 1U size?

*https://www.crestron.com/Software-Firmware/Software/VisionTools-153;-Pro-e/VT-Pro-e-6/6-2-01-31* -------------------------------------------------------------------------------------------------

Here is a link to the Protocol Document. I am creating my own module since the MC-8 is a complete different set of commands. So far, I am finding all the commands in the doc to be good.

I'm sure that the shade power supply/hub has the same issue as the other hubs. It totally makes sense. Eventually, Crestron will fix it, but not until they can find something else to break.

No, not needed for the RMC3 to connect. Just need SSH turned on and configured properly in your module. You can also try changing the SSH connection type to "Unsecure" in the Parameters if you simply

Remote System Definition

I don't have either a DIN-CEN-CN-2 nor the CAEN-BLOCK-CENCN-2-POE in my program. I do however have a?CSA-PWS10S-HUB-ENET, and it very possibly that I only saw this pop up on this project after I

RSD?

I've noticed the same thing with regards to the CAEN-BLOCK-CENCN-2-POE. I was told that there is a known issue with the later versions of Toolbox and these devices. IP ID conversion makes sense