开云体育

Absolutely Change your password on your router and turn auth on your processor Then spoof your ports on your firewall don't use the normal ports Numbers externally. please follow read the crestron

If you do an internet search on nk.exe you will find that nk.exe is part of the? Windows Embedded CE OS and starts up very early in the boot process. If the program has work for years without issues,

Hi, Can anybody shed any light on this error please? 3. Notice: nk.exe # 2020-04-13 11:20:25? # CRM1: packet length(8), bytes read(8) 4. 5.? 92 6.? 06 7.? 20 8.? 03 9.? 03 10.? 00 11.? 05

Thank You, Dustin!!!! (I must have missed it, in the documentation...:)? )

AV Master, I've successfully done 3 Lutron integrations in the last few months. If you'd like another set of eyes to look in, I'd be happy to help sometime this week. Reach out if interested:?

Bus numbers set? Latency ok? Mac address routing?

Hey all! We are using a Denon HEOS multiroom system in our home. The crestron system (RMC3/TSW752) is expanded with MP-B10 Keypads in each room, so we don't need our smartphones to control the music.

If it was "easy", anyone could do it. Lutron QS and Crestron have been integrated successfully THOUSANDS of times, so there are only three possibilities... 1. The Lutron processor is defective. 2.

Lutron supports these modules have you reached out to them?

I have crestron and lutron at my house. Almost all the time it works fine. But I’ve had the situation where If I reprogram the lutron homeworks qs processor it’s then the crestron won’t connect

Thanks for the insight but yeah, Im using the QS modules for sure. ?I’m moments away from throwing in the towel on this one. its especially frustrating when little creeper things like this happen

So this is a bad idea but it’s my house, where bad ideas reign supreme ? In the living room I have a Cisco VTC camera -> DM-TX-201-C ---(direct DM link)--> DM-RMC-100-C --> Cisco C-series CODEC

Got it thanks!? I am sending this to Touchpanels so I send through the DM to the 1542 and stream to the TSWs.

Ctrl+Shift+b would be the shortcut you're looking for.

Hi All, I seem to remember in the back of my mind, hearing that there was a way to automatically populate the signal names on a module. I can't find anything about it.... If you just hit return on

Interesting! I wasn't fully aware of that, though I haven't seen any issues yet. I'm running the following DBs with SMW 4.11.06 Device Database: 114.00.001.00 Crestron Database : 88.00.002.00

Can't stay on 1.504 unless you want to keep your device database old on your computer - the latest couple device databases break simpl+ modules completely when loaded to processors with older

yes, that will work, but everytime the touchpanel reboots there is a message with a warning in TSW, dont kow how to disable it

Kyle, I think you have to get it up to at least v1.10.60 first to be able to FTP, then it's recommended to go to v1.12.17.? ?From there you should be able to make the jump to hyperspace... Me

I haven't seen these responses (just might never have noticed), and not to be overly simple, but are you sure that you're using the *QS* modules vs the older *HWI* modules? The fact that your system