开云体育

we are experiencing an issue by where there is a meeting that will appear with "No Title" there is no rhyme or reason at to why this title has no information. If I go to the touch 10 the meeting has a

Thanks for the follow-up! Any configs you can send would be appreciated. Currently, I am wrestling with a SG350 in our lab. We have a few installations where we have Dante installations where our

The below is what I immediately thought when I read you post, I have not tested it (just taking a break from working and saw this). To anticipate the short values you can start from the end of

Unless you're daisy chaining the control of displays to several displays, there is no reason to use the ID. The MDC protocol allows you to use "0" to talk to all displays.

I have 2 powerwalls installed at my home. Let me know if you need someone to test any code for the powerwalls.

I have two Tesla powerwalls installed and running at my house. Let me know if you need somebody to test anything with the powerwalls.

i can't find the updated module in files... mark

Interesting that this thread would pop up again right after I just dealt with the same thing on a project that is currently in progress. I configured an isolated network with three Cisco SG-350X

I too have seen I can change the RTSP/MJPEG analog join on the fly or hard code it in VTPro with either option and my video streams play regardless of what its set to.

No, I didn't!

Were you able to find one yet?

Sorry I meant 27. Not 127

Sorry, I meant 27, not 127

Convert each byte to an integer with hextoi. Then use makestring with a %c for each byte. Ie: 1B hextoi will =127. %c of 127 = \x1B. I think that's how I did it recently anyway.

yeah i figured 0LS is not what i am looking for, perhaps i need to find a way to save all the used transmitters. I need to turn PoX off due to a bad design issue, the matrix can only power 24 inputs

There is a Sony Discrete codes for Android models, other than that Sony says the codes have not changed Sony Discrete Input Codes (work on 2017 Sony OLED TVs)

Hi, 0LS command returns signal presence, this is not what you are looking for. I dont have the manual in front of me, you should search for "input tie status" or "output tie status", which returns

Now that I have written that i realized that wont work, since this command searches for sync state. so, whats the easiest way that I can make 32 digital signals that represent inputs usage so i can

this is exactly what i was doing but i faced some trouble while trying to turn On/Off the transmitters based on their status what i am trying to do is to only send power over XTP to inputs that are

The SIS protocol is so simple I doubt anyone would have built a module. I use a ATOS with some logic to convert analogs to ASCII values to build ties and an SIO for any static commands. Lincoln --