开云体育

If you have a *serial* signal, the simplest solution is Serial Pacer + Serial IO like this https://i.imgur.com/rtMdusU.png https://i.imgur.com/rtMdusU.png If it's analog, you have a few options,

its a bit clunky, but you can scale it twice using two analog scalers with io limits. 0-65535 input down to 0-1000 output then convert 0-1000 input it to -800 through +200 ouput, making sure the

In case it's helpful, I was able to image an sd card from a working TST-602 touch panel and restore that image to a new sd card for another TST-602 panel that was getting stuck on the Crestron bootup

isblk -- a good command I didn't know about. It always amazes me how many useful commands are built into Linux. Thanks.

Did you by chance have the LAN port of the DMPS connected while it was in the office and then disconnected onsite? For some reason the 4K-150 lose comms on the DM out when the LAN port is

Thanks Guys....just curious. I'm a retired dealer, just trying to keep my home (former show home for my old company) up and running. Once you get used to a Crestron Home...it's just too hard to switch

*See also* ddrescue <http://www.forensicswiki.org/wiki/Ddrescue>.

+1 to Steve's answer Also, if your card does not show up with the "df" command, it may not have been mounted automatically. You can find out what device it is with "lsblk". And if you have a corrupt

I've seen control over HDBaseT not work once sync is lost. Once sync was regained then 5-60 seconds later control was restored. This was with an NEC projector and a DM 16x16.

FIrst of all, let me say I never tried this with a Crestron SD card. Proceed at your own risk. But from a Linux machine, I have made clones of other media (e.g. floppies with other operating systems,

So here's a interesting issue that we can't seem to resolve. First test system DMPS3-4K-150C Epson Pro L 1100U We mocked this up in our office to test the HDBASET direct out of the DM port of the

They were under $1,000 dealer while new..so I would expect them to be cheap now. The best part about the TSWx60's for me seems to be that the stupid "hard buttons" on the side aren't visible with the

The 1060's are out so I think a lot of places are dumping older in stock hardware... .

Nope, I've picked a few for $200. Just be careful, most I see on eBay are "screens only", a replacement screen.

Hey All, Did I miss a memo? Is there a technical problem with the TSW 1050/1052 Touchpads, other than being a bit old. They seem to be flooding the after-market? D

There is a keypad decoder in the Crestron database you can use.

This can be done with the following symbols: 1 SAWPULSE, 1 STEPPER, 1 DECADE, and 3 BUFFERs Try to figure out how to assemble them on your own but don’t be afraid to ask for help if you get stuck :)

When you compile a System Builder file creates a simpl file a uploaded file to the controller and a touch screen file to upload to the screen. You can use the simpl file to make the changes. Ok.

Hi! Yes the program is running properly, I have to siwtch a B&K for a denon. I created already my module with the IR learner but I dont get where to import it and make the connections. The program is

Check out the Crestron module Channel Presets Extender. It's under "Device Extender Modules" Crestron@...> wrote: